User Instruction Manual SPUM60X SPUM90X
CONTENTS 1) WARNING 2) INSTALLATION INSTRUCTIONS 3) OPERATION 4) LIGHT REPLACEMENT 5) CHARCOAL FILTER INSTALLATION 6) MAINTENANCE 7) ATTENTION 8) TROUBLESHOOTING 1
1. WARNING Young children should be supervised to ensure that they do not play with the appliance. The appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervised or instruction concerning use of the appliance by a responsible person for their safely.
2. INSTALLATION Preparation 1. The cooker hood should be placed at a distance of 65-75cm (26-30inch) from the cooking surface for the best effect. 2. Drill a hole in the cupboard, 570*265(mm) for model SPUM60X and 865*265(mm) for model SPUM90X. Make sure the distance between the edge of the hole and the edge of the cupboard edge is at least 35mm. 3. Take off the filter and the two lamps. Remove the two screws on the panel. And then take off the panel. Installation Method 1 1.
Method 2 1. Use four ST4*8mm screws to fix the mounting bracket onto the hood. Then put two ST4*30mm screws into the wall. Hang the hood onto the wall. 2. Use eight ST4*14mm screws to fix the hood onto the cabinet from the sides. Method 3 1. Use four ST4*8mm screws to fix the mounting bracket onto the hood. Then put two ST4*30mm screws into the wall. Hang the hood onto the wall. 2. Use four M4*35mm screws, eight washers and four nuts to fix the hood onto the cabinet from the top.
3. OPERATION: 1）Push the low button, indicated by a fan with 3 blades, and the motor will run at a low speed. An indicator light will also illuminate. Push it again and the motor will stop. 2）Push the medium button, indicated by a fan with 4 blades and the motor will run at a medium speed. An indicator light will also illuminate. Push it again and the motor will stop. 3） Push the high button, indicated by a fan with 5 blades and the motor will run at a high speed. An indicator light will also illuminate.
6. MAINTENANCE 1． The rangehood and its filter mesh should be cleaned regularly in order to keep in good working order. Because the grease filters are made of metal, do not clean the filters with detergents that will corrode metal products. Clean the filters as below: Method one: Put the filter in water (40℃-50℃), pour in some grease-loosening detergent, soak it for about 2-3 minutes and then clean it with a soft brush. Do not brush too hard, as it may damage the filter.
SPUM60X Dimensional Drawing SPUM90X Dimensional Drawing
8.
WARRANTY REGISTRATION CARD Congratulations on your new appliance purchase! To help care for your investment, be sure to register your appliance online. Registration will help you if you need to arrange service in the future, and serves as a record of your purchase – including critical information like model number and serial number – that you can refer to at any time. Simply visit the below website, or ask your retailer for help: www.applico.co.
