Contents 1.1 1.2 1.3 1.4 1.5 1.6 7 Introduction This user manual Intended use Manufacturer liability Identification plate Disposal 2 Description 3 Use 9 10 12 Before first use Operation Keep Warm function Water temperature suggestions 4 Cleaning and Care 4.1 4.2 4.3 4.4 4.5 4.6 4.7 7 7 7 8 8 8 9 2.1 Product description 2.2 Description of parts 3.1 3.2 3.3 3.4 EN 1 Instructions Instructions Maintenance Cleaning the surfaces Ordinary daily cleaning Cleaning the filter Descaling What to do if...
Important Safeguards RECOGNIZE SAFETY INFORMATION This is a safety alert symbol. This symbol alerts you to potential hazards that can result in severe personal injury or death. UNDERSTAND SIGNAL WORDS A signal word - DANGER, WARNING or CAUTION - is used with the safety alert symbol. DANGER denotes the most serious hazards. It means you could be killed or seriously injured if you do not immediately follow the instructions.
WARNING To reduce the risk of fire, electric shock, personal injury or damage when using the appliance, follow basic safety precautions, including the following: Follow all safety instructions in order to use the appliance safely. • Read this user manual carefully before using the appliance. • To protect against electric shock and injury to persons, do not immerse the appliance, the power cord or the plug in water or any other liquid.
Important Safeguards For this appliance • The kettle can get very hot during operation. Do not touch the hot surfaces. Use the handle. • Make sure the handle is fastened properly. Do not use the kettle if the handle is loose. • Unplug the kettle when it is not being used, before cleaning and if you notice any fault. Let the appliance cool down before putting on or taking off parts, and before cleaning. • Always use the kettle with the scale filter in place. • Do not overfill the kettle (max. 1.
1 Instructions 1.1 Introduction Key information for the user: Instructions General information on this user manual, safety and final disposal. Description Appliance description. Use Information on using the appliance Cleaning and care Information for proper cleaning and maintenance of the appliance. Safety instructions Information Advice 1.
Important Safeguards 1.6 Disposal Warning • This product contains a chemical known by the State of California to cause cancer, birth defects or other reproductive harm. • This appliance can cause low-level exposure to some of the substances listed, including benzene, formaldehyde, carbon monoxide, toluene, and soot. 1.
Description EN 2 Description 2.
Description 2.2 Description of parts Lid with soft opening (3) Anti-drip spout (1) 1 3 The large stainless-steel spout allows water to be poured easily and without spilling. The lid has a soft opening button (3) which allows it to open progressively to prevent the sudden release of steam. Scale filter (2) Water level indicator (5) 2 5 The stainless-steel filter is located behind the spout. It retains any scale present in the water.
Description EN Base with 360° connection and temperature indicators (7) Control panel (6) 6 START/STOP key Starts/stops the heating cycle. The LED lights up when the cycle is started. Temperature selector Allows you to select one of 7 temperature levels. The temperature indicator LEDs turn on when the boiling cycle is started. Keep Warm function key Allows you to keep the water at the selected temperature for 20 minutes. When activated, the LED of the Keep Warm function key lights up.
Use 3 Use Electrical Shock Hazard • • • • • Plug into a grounded 3-prong outlet. Do not remove the ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire or electric shock. Volts: 120 Volts AC only. Hertz: 60 Hz Your kettle has a 3-prong grounded plug. To reduce the risk of electrical shock, this plug will fit into an outlet only one way. If the plug does not fit in the outlet, contact a qualified electrician.
Use 1. Remove all stickers and labels from the kettle and clean the outside with a damp cloth. 2. Remove the scale filter behind the spout and wash it under running water. 3. Return the filter to the correct position. 4. Remove the kettle from its base, press the button to open the lid and fill it to the maximum level. 5. Close the lid and place the kettle back on its base. Check that the pre-set temperature is 212°F (if this not the case, see point 7 of section “3.
Use 3.2 Operation 1. If necessary, shorten the length of the power cable by winding it under the base. 3. Press the button (1) to open the lid. 1 2. Hold the kettle by its handle when removing it from the base.
4. Fill the kettle with the required quantity of water, referring to the marks on the level indicator (2). 2 6. Insert the plug into the power socket. All the LEDs will come on and a beep will sound to indicate that the appliance has been turned on. The LEDs of the START/ STOP and Keep Warm keys switch off after 2 seconds and the default temperature set is 212°F. 7. Use the temperature selector (3) to select the required temperature. Move the temperature selector to the left to decrease the temperature.
Use 10. Pick up the kettle by the handle and pour the hot water into the desired recipient (cups, teapot, etc.). 11. If no command is given within 60 seconds, the kettle will enter Stand-by mode (all LEDs off). Pressing any key will reactivate the kettle, placing it in Temperature SELECTION mode, starting from the last temperature set. Now follow the operations from point 7 onwards in section “3 Use”.
Use Drink EN 3.
Cleaning and Care 4 Cleaning and Care 4.3 Cleaning the surfaces 4.1 Instructions To keep the kettle’s outside surface in good condition, it should be cleaned regularly after use. Let the kettle cool down first. Improper use Danger of electrocution • Unplug the kettle before cleaning it. Hot appliance Danger of burns • Let the appliance cool down before cleaning. 4.4 Ordinary daily cleaning Always use only products which do not contain abrasive substances or chlorinebased acids.
4.5 Cleaning the filter Important 3. Put the filter back in position behind the spout. When washing the filter, make sure your hands are clean and free of any residue from soap, creams or other products which could contaminate the water. 1. Open the lid and extract the filter. 2. Wash the filter under running water with the aid of a soft brush.
Cleaning and Care 4.6 Descaling Regularly removing any scale deposits inside the kettle will prolong your kettle's life, and ensure maximum performance and energy savings. The kettle can be descaled using specific descaling products. Improper use Risk of damage to the appliance • Do not use descaling products for cleaning bathrooms or kitchens, or scented products. Leave the descaling product to act, then rinse thoroughly.
Cleaning and Care Problem EN 4.7 What to do if... Cause Pouring water becomes more Scale build-up on filter difficult The base of the kettle has excessive scale build-up The kettle turns off before boiling Solution Check that the filter is clean and correctly positioned Descale more frequently Too little water has been Increase the quantity of added to the kettle or there is water until you reach at least no water inside the kettle.