Cappa aspirante Exhaust hood Hotte Dunstabzugshaube Exaustor Campana extractora NL Afzuigkap SV Köksfläkt DA Emhætte NO Kjøkkenventilator RU Вытяжка PL Okap kuchenny IT EN FR DE PT ES Istruzioni d’uso Instruction of use Prescriptions d’emploi Gebrauchsanweisung Instruções para utilização Modo de empleo Gebruiksaanwijzingen Bruksanvisningar Brugsanvisning Bruksanvisning Инструкция по эксплуатации Instrukcja obsługi
EN Installation TRANSLATION OF THE ORIGINAL INSTRUCTIONS Safety Instructions Read all instructions ! This manual should be kept for future reference. If the appliance is sold, given away or you move to a new house, make sure that it stays with the product. Closely follow the ! Read the instructions instructions set out in this carefully: they contain manual. The manufacturer important information declines all responsibility for regarding installation, use any faults, damage or fires and safety.
EN Installation only with some models or items that are not supplied and that have to be purchased separately. by a person responsible for their safety. Children should be supervised to make sure that they do not play with the appliance. Do not use the hood if the grid is not mounted correctly! The hood should NEVER be used as a support surface unless specifically indicated.
EN Installation Frying must be carried out with care so that the oil does not overheat and catch fire. When the hob is in use, the accessible parts of the hood may become hot. Comply with local authority regulations regarding the technical and safety measures to adopt for discharging the fumes. The hood should be cleaned regularly, both internally and externally (AT LEAST ONCE A MONTH and in any case, comply with the maintenance instructions provided in this manual).
EN Installation electronic equipment. Dispose of the product in accordance with local waste disposal regulations. For further information on treatment, collection and recycling this product, please contact your appropriate local authority department, the household waste collection service or the shop where you purchased this product. This appliance has been designed, tested and built in compliance with the standards on: • Safety: IEC/EN 603351; IEC/EN 60335-2-31, IEC/EN 62233.
EN Installation use a duct of the maximum diameter indicated in this manual. In the horizontal section, the extraction duct must have a slight upwards inclination (about 10°) so that it can convey the air to the outside more easily. If the hood is fitted with activated carbon filters, they should be removed. Connect the hood to the extraction ducts and wall outlets that have a diameter that is the same as the air outlet (connecting flange).
EN Installation Installation 90°). ! Avoid drastic changes in the duct cross-section. ! Use a duct that is as smooth as possible inside. ! The duct must be made of certified material. The minimum distance between the pan supports on the hob and the lowest part of the hood must not be less than 50cm for electric hobs and 65cm from gas or mixed fuel hobs. Filter version The air will be degreased and If the installation instructions for the gas hob specify a deodorised before being returned to the room.
EN Installation Save these instructions Mounting plug is not located in an accessible area after installation, use a compliant two-pole switch that assures the complete disconnection of the mains under overcurrent category III conditions, in accordance with installation regulations. Before installation: • Make sure that the product is of a suitable size for the area in which it is to be installed.
EN Installation below and around the area of installation of the hood (wall or ceiling) in order to have better access. Otherwise, protect the furniture units and all the parts involved in the installation as much as possible. Select a flat surface on which to place the hood and the supplied parts and cover it with a protective cover.
EN Installation 9-BUTTON CAPACITIVE CONTROL PANEL. FUNCTION BUTTON OFF/ ON / Stand-by. Fan speed 1. Fan speed 2. Fan speed 3. Boost Function. Light On / Off / Adjustment. 24h function . Switch off delay function. Clean filter indicator. ON / OFF: To switch off the hood (OFF) or to put it back in Stand-By mode, touch the When power is turned on to the hood, it will be in the OFF mode. The symbol . FAN SPEED SELECTION. icon is lit dimly and the functions are disabled.
EN Instructions for use 7 minutes, after which it Tapping the symbol twice quickly automatically reverts to speed 3. when the light is off will set it to Touch the same button to disable the maximum brightness. function . The icon flashes while “Tunable White” function. the boost function is active and it will not be possible to activate the delayed switch off function. Touching the , and symbols at the same time activates the DELAYED SWITCH OFF FUNCTION "Tunable White” function, i.e.
EN Instructions for use CLEAN FILTERS INDICATOR Every 100 hours of actual hood operation, the symbol will light up to indicate that the filters should be cleaned / replaced. (see MAINTENANCE in the CLEANING section). Touch the seconds to reset it. symbol for 3 AUTO-VENT 2.0 FUNCTION (Connection to a SMEG enabled hob) This function is only available in combination with a SMEG hob with wireless connectivity. It allows the hood to operate automatically in response to commands from the hob.
EN Instructions for use fires caused by incorrect maintenance or failure to follow the above instructions. Grease filter Retains the particles of grease produced during cooking. It should be cleaned at least once a month (or when the filter saturation indication system - if installed on the model in your possession - indicates that it is necessary to do so) using a nonaggressive detergent, either by hand or with a short, low temperature, dishwasher cycle.