User Manual

User instructions
17
ENERSAVE
This option can be selected with the wash programme of choice to
further reduce energy consumption. This ensures perfect drying and
greater control of rinsing temperatures, which can be kept at lower levels
for significant energy saving.
Enersave is activated
automatically every time
a wash cycle is
selected (except for programs that do not include the final drying phase;
see programs table) and can be disabled before the program is started.
Flexi Tabs, once selected, remains enabled until intentionally disabled.
When the function is activated, opening of the door must not be
impeded in any way; do not leave anything in the space in front of the
door necessary to allow it to open.
Do not re-close the door during automatic opening as this would
damage the mechanism. Wait for the pushers to retract before re-closing
the door.
"Flexi Tabs
"
(on some models only)
The option is optimised for use of detergents which are complete with
salt and rinse aid, known on the market as, "triple action", etc. With this
option activated, any salt and rinse aid If you wish to use detergents
which already contain salt and rinse aid already in the dishwasher will
not be used.
With short programs, because there is less time for them to dissolve,
tablets may fail to wash effectively and undissolved residues may be left.
Powder detergents are more suitable for these programs.
- N.B.: even with the "Flexi Tabs" option selected, the
regenerating salt/rinse aid lights will still stay on if their
containers are empty.
IMPORTANT: when no longer required, the option must be disabled
(the light goes out).
If the water hardness has been set on a value above H3, and the “Flexi
Tbas” option is activated, the relative light flashes, warning of a setting
error. Multi-function products are not suitable for use with very "hard"
water; this does not prevent the use of the option, but the washing
results might not be of the best.
HYCLEAN
Increases the temperature of the final hot rinse to 70°C to ensure a further
reduction in the bacteria level. If the temperature in the tank falls during
this stage of the program (e.g. because the door is opened or due to a
power blackout), the light of the option and the program lights flash to warn
that the additional washing phase has not been completed successfully.
This does not mean that the wash program has been less effective than
usual.