Technical data

Instructions for the User

10.5.2 Setting the cleaning cycle with electronic analogue clock

FUNCTION SELECTOR KNOB

ELECTRONIC ANALOGUE CLOCK

Position the function selector knob to the symbol. Hold down the

symbol at the same time as pressing the symbol .

The display will appear as shown in figure 1 with the number 1 flashing

and the segments up to 6 illuminated to show the minimum duration of

pyrolysis (an hour and a half). Press the

key again for 1-2 seconds to

increase the duration of this operation up to a maximum of three hours.

Figure 2 shows a period of 2 hours, 40 minutes.

6-7 seconds after the knob has been set at the

symbol and the

duration of pyrolysis has been adjusted, the oven will begin the cycle and

after each minute one of the segments which is lit up will go out.

The start of the pyrolysis cycle can be programmed within the next 12

hours.

After setting the pyrolysis duration, press the

key and set the pyrolysis

start time by pressing the

/ keys.

The internal segments will remain on and the external ones will flash until

the current time is the same as the cycle start time.