User's Manual

FLASHWAVE4
User Guide
Key Features of FLASHWAVE4
Powered by General AA 1.5V x 2 batteries
2.4Ghz frequency operation
Four groups & Eighty three selectable channels
Maximum range of 200meters
Ability to function as a camera shutter release
Multiple ports for connection to portable flash or studio strobes
Ability to operate in extreme temperatures (-20℃~50℃)
Set Up
1 Battery Installation
Prepare 2pcs of FLASHWAVE4.
Open the battery cover of each item.
Install 2pcs of AA batteries in a right battery polarity. Follow the polarity direction
indicated on the inner picture.
2 Power on / off
Switch on the power of them.
Press “M”button to choose “TX/RX”mode of them.
Press the channel up/down button to choose the channel.
For group shooting, press “A”,”B”, “C” or “D” button .
3 Wireless release shooting
Connect the camera release jack of the release cable to the camera’s electronic
shutter release input.
Check the status LED is blinking when the shutter button is pressed.
4 Mode
-TX/RX MODE – This mode does not distinguish the transmitter or receiver.
-TX-ONLY – This mode is for Transmitter only
-RX-ONLY – This mode is for Receiver only