User's Manual

SMCWK01-Z Key Pad Quick Start Guide
Copyright
©
2010 SMC Networks Page 1
All Rights Reserved
SMCMWK01-Z08172010
8/17/10
1 Pre-Installation Guidelines
A. With a Phillips screwdriver, remove
the screw from the battery cover in
the back of the key pad and
remove the cover.
B. Find the two supplied CR2 3-volt
lithium batteries.
C. On the front of the key pad, hold
down the 2 and 8 buttons while
inserting one of the batteries in th
back of the key pad (positive end
up).
e
D. Continue to hold down the 2 and
8 buttons until the
button
lights green, then release
immediately.
E. The button flashes green 3
times every 5 seconds. This means
the device is in Search mode and
can be added to the TouchScreen.
If the
button stops blinking, touch the STAR
to restart Search mode.
butto
F. Insert the other battery and replace the key pad back
cover.
n
2 Adding a Key Pad
A. From the Home screen, touch the Settings widget.
B. When the TouchScreen Keypad screen appears, touch
the numbers to enter the Installer keypad code (this
code is the same for all TouchScreens installed by your
company).
C. When the Technician keyboard pad appears, enter your
Technician ID and touch Done.
D. When the Technician Settings menu appears, select Key
Fobs & Pads > Add a Key Pad. The Locating Key Pads
screen appears.
E. Touch Next, and the system scans the premises for key
pads that can be added, which must meet the following
requirements:
- Defaulted
- Not currently paired with another TouchScreen.
- In Search Mode (blinking 3 times every 5 seconds)
F. Follow the system prompts to complete the add process
and pair the key pad with the TouchScreen.
Note: If no available key pads are found, touch Cancel Key
Pad Add to return to the Technician Settings menu.
G. Arm the system from the key pad to test that the key
pa hd as been added successfully.
3 Deleting a Key Pad
Deleting a key pad from the premises removes it from being
used to perform actions in your security system. You should
delete a key pad:
If the key pad is being relinquished by the customer. ¾
¾ To reset the key pad to factory default settings by
deleting the key pad and re-adding it to the TouchScreen
immediately.
Congratulations on purchasing your SMCWK01-Z Key Pad.
The SMCMT02-Z Key Pad is a professional state-of-the-art device that lets you arm and disarm your system from additional locations in your home. It also provides an emergency alarm
function.
To delete a key pad from the TouchScreen:
A. Perform steps A through D in step 2, “Adding a Key Pad
to the TouchScreen”.
B. When the Technician Settings menu appears, select Key
Fobs & Pads > Delete a Key Pad. The Remove Key Pad
screen appears.
C. Touch the key pad icon that you want to delete. A
confirmation dialog appears.
D. Touch Yes. The key pad is deleted from the
TouchScreen.
E. After deleting the key pad from the TouchScreen, press
the
button to reset the device to default and place
it in Search mode so it can be added to a TouchScreen
again.
4 Troubleshooting
If a key pad does not appear to be working properly or is not
being located by the TouchScreen during the Add process:
¾ Verify that two good batteries have been properly
installed (see step 1, “ .” Pre-Installation Guidelines
¾ Confirm that the key pad has been defaulted.
Congratulations!
You have successfully added key pads.
continued on next page