802.
SMC Networks 20 Mason Irvine, CA 92618 U.S.A. Copyright © 2013 SMC Networks All Rights Reserved Information furnished by SMC Networks, Inc. (SMC) is believed to be accurate and reliable. However, no responsibility is assumed by SMC for its use, or for any infringements of patents or other rights of third parties which may result from its use. No license is granted by implication or otherwise under any patent or patent rights of SMC.
Compliance Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
IMPORTANT NOTE: FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. IEEE 802.11b/g/n operation of this product in the U.S.A. is firmware-limited to channels 1 through 11.
第十四條 低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現 有干擾現象 時，應立即停用，並改善至無干擾時方得繼續使用。 前項合法通信，指依電信規定作業之無線 電信。低功率射頻電機 須忍受合法通信或工業、科學及醫療用電波輻射性電機設備之干 擾。 End Product Labeling This transmitter module is authorized only for use in device where the antenna may be installed such that 20 cm may be maintained between the antenna and users. The final end product must be labeled in a visible area with the following: “Contains TX FCC ID: JI5-359333DB24”.
Contents Compliance ............................................................................................................. iii Contents .................................................................................................................. vi About this Manual.................................................................................................... 7 1 Introduction...........................................................................................................
About this Manual This User’s Manual describes how to install and operate your 802.11b/g/n Wireless LAN Module. Please read this manual before you install the product. This manual includes the following topics: Product description and features.
1 Introduction The JI5-RT359333DB24, which is based on the RT35933 solution, is a dual-band mode 802.11b/g/n wireless LAN embedded Mini-PCI module for Wireless Cable Gateway Router. JI5-RT359333DB24 will be a RF module of AP board. Additionally, provide new feature to existing Wireless Cable Gateway Router products. Features Embedded to any AP with Mini-PCI type -B slot. • IEEE 802.11 b/g/n compatible. • Backward compatible with IEEE 802.11b standard.
What is Wireless LAN Wireless Local Area Network (WLAN) systems offer a great number of advantages over traditional wired systems. WLAN is flexible and easy to setup and manage. They are also more economical than wired LAN systems. Using radio frequency (RF) technology, WLAN transmit and receive data through the air. WLAN combine data connectivity with user mobility. For example, users can roam from a conference room to their office without being disconnected from the LAN.
Wireless LAN Modes Wireless LANs can be configured in one of two ways: 1. Ad-hoc Networking Also known as a peer-to-peer network, an ad-hoc network is one that allows all workstations and computers in the network to act as servers to all other users on the network. Users on the network can share files, print to a shared printer, and access the Internet with a shared modem.
Notes on Wireless LAN Configuration When configuring a wireless LAN (WLAN), be sure to note the following points: • • • Optimize the performance of the WLAN by ensuring that the distance between access points is not too far. In most buildings, WLAN Adapters operate within a range of 100 ~ 300 feet, depending on the thickness and structure of the walls. Radio waves can pass through walls and glass but not metal.
20 Mason Irvine, CA. 92618 U.S.A. http://na.smc.
