Quick Start Guide

LTE CPE
SRW310 Router
Quick Start Guide
Introduction
SRW310 is a highly advanced LTE outdoor multi-service product
solution specifically designed to meet integrated data needs for
residential, business and enterprise users. The product supports
advanced Gigabit networking functionalities. It enables wide
service coverage and provides high data throughput and
networking features to customers who needs easy broadband
access.
Panel of device
1
· I/O panel of ODU ·
Packing List
Make sure you have everything you need to properly configure the
device.
ODU PoE Ethernet cablePower supply
Stainless steel
clamp
Cable glands Slotted end cap
2
How does it work
1. Connect Power Adapter to PoE injector.
2. PoE injector provide the power to ODU via LAN cable.
3. PC connect LAN Cable to PoE, then PC can surf the Internet
when ODU access the LTE network.
This quick installation guide shows you how to configure your ODU
in order to access the Internet.
Configure hardware
Please make sure that you are familiar with all accident prevention
and safety procedures necessary for working at height and with
electricity before start to intall the device.
DO NOT install the ODU during a lightning storm.
CAUTION
Insert a SIM Card to the Slot
Make sure the ODU is turned off before you insert your SIM card. It
is recommended to NOT connect the PoE cable when you do this
step. Otherwise, the SIM card may be damaged.
CAUTION
3
Step 1 CAT5e cable to thread through the cable glands.
Step 2 Connect the end of the CAT5e Ethernet cable to the PoE port
of the ODU.
Step 3 Wring the cable glands into ODU and seal tightly.
NOTE: Make sure you have inserted the SIM card into the ODU.
Mount the ODU
See the installation instructions to mount the ODU correctly.
Header Connection
4
Mounting Bracket
The ODU can be mounted on an antenna pole or mast or on a wall
using the supplied mounting bracket.
· Choose a mounting point that is sturdy enough to hold the ODU,
even during high winds.
· When choosing a location to install the ODU, please be noted that
the ODU’s front panel should point towards your service provider’s
nearest base station. You do not need to be able to see the base
station from the ODU’s position. However, if you experience
difficulties with signal reception, a Line of Sight (LoS) connection
may produce better results.
· It is suggested that you transport the ODU to its intended
installation location in its original protective package.
To obtain the best radio signal level and connection quality, the CPE
antenna should be aimed towards the best eNB or BS directly.To
search for the best eNB direction, the user can rotate the CPE slowly
and tilte CPE slightly to find the best signal direction. The CPE radio
signal strength level can be observed from the RF LEDs mounted on
the lower panel as shown below. The more LEDs on, the better the
signal strength.
Choose Location
5
Connect the PoE
Place a CAT5e Ethernet cable (not included) from the location of
your intended Router to the desired PC location.
If you intend to use cable clamps or other methods to secure the
cable, do not tighten them until you finish installing the Router and
ODU.
ODU
Computer
PoE Adapter
Hardware connections of Router
6
To connect the CAT5e Ethernet cable:
Step 1 Connect the CAT5e Ethernet cable to PoE.
Do not connect a computer or switch directly to the PoE port due to
high PoE power.
CAUTION
Step 2 Connect the power adapter to the PoE injector. The POWER
LED turns on a solid green-yellow once connected.
Step 3 Connect the included Ethernet cable from the computer to
one of the Router's Ethernet ports.
LED Behavior
When set up the Outdoor Unit, the LED will have the following
behavior.