User's Manual

Page 1 of 2
Rev. 10-14-2010
Smarthome Limited Warranty – Smarthome warrants to original consumer of this product for a period of 2 years from date of purchase, this product will be
free from defects in material & workmanship & will perform in substantial conformity with its Owner's Manual. Warranty shall not apply to defects caused by
misuse or neglect.
U.S. Patent No. 7,345,998, International patents pending © Copyright 2010
Smarthome, 16542 Millikan Ave., Irvine, CA 92606, 800-762-7845
Installation
1) At the circuit breaker or fuse panel, disable the circuit
supplying power to the fixture
2) Remove the wallplate from the switch you are replacing.
Then unscrew the switch itself and pull it out from the
junction box.
3) Disconnect the wires from the switch you are replacing and
ensure you have ½ inch of bare wire on the ends
4) To correctly identify the LINE, LOAD, and NEUTRAL wires,
enable power to the switch from the circuit breaker or fuse
panel, use a line voltage meter, then turn the breaker off
again. See Figure 1 to properly connect your wires to
KeypadLinc.
5) Ensure that all wire connectors are firmly attached and that
there is no exposed copper except for the GROUND wire
6) Orient KeypadLinc with the Set button at the bottom, gently
place it into the junction box, and then screw it into place
7) Enable power to the switch from the circuit breaker or fuse
panel
8) Test that KeypadLinc is working properly by turning the load
on and off from KeypadLinc
9) Reinstall the wallplate
Quick-Start Guide
KeypadLinc
™
- INSTEON
®
6-Button Keypad Controller
with On/Off Switch (Dual-Band)
Model: 2487S
Preparation
Installation should be performed only by a qualified electrician or
by a homeowner who is familiar and comfortable with electrical
circuitry. If you have any questions regarding installation, we
suggest consulting an electrician. If you have any questions
regarding setup, contact the INSTEON Gold Support Line.
Tools Needed
• Phillips and standard screwdrivers
• Wire cutter / stripper
• Voltage tester to identify wires inside the junction box
Introduction
Control lights and other non-dimmable devices at the touch of
a button. Send commands to KeypadLinc from an INSTEON
Controller. Or conveniently control other Linked INSTEON
devices by using the buttons on KeypadLinc. Supports voltages
from 120 to 277V, as well as 50 / 60Hz auto-detect. KeypadLinc
also works as an INSTEON signal repeater and can be used to
bridge the power phases in your home (like an Access Point,
#2443
)
.
Using KeypadLinc
Each of the KeypadLinc buttons is considered a “Scene button”, meaning you can use any of the buttons on KeypadLinc to
create INSTEON scenes. Each button will control its own scene, only sending commands to devices Linked specifically to
that button.
• Tap the desired Scene button to activate the scene
The button’s LED should turn on solid and its Responders should respond appropriately
• Tap the desired Scene button to deactivate the scene
The button’s LED should turn off and its Responders should respond appropriately
Figure 1
Set button (push)
Air gap (pull)
Dedicated On/Off
Scene buttons
(load-controlling)
Secondary
Scene
buttons
Wallplate
(sold separately)