User's Manual

Page 1 of 2
Rev. 012208
Quick-Start Guide
INSTEON™ Thermostat Adapter, Totaline™ / Venstar™
M
Model: #2441V
INSTEON Thermostat Adapter
Introduction
The INSTEON Thermostat Adapter adds remote control and monitoring
to 3 models of Totaline / Venstar brand thermostats. It simply plugs into
the bottom of compatible thermostats and communicates via INSTEON
RF giving you wireless remote control and monitoring from anywhere in
your home, or the world.
The 3 compatible models are:
1-Day Programmable Venstar Thermostat (30410A)
7-Day Programmable Venstar Thermostat (30411A)
7-Day Programmable Dual-Fuel Venstar Thermostat (30412A)
Installation
1) Simply plug the INSTEON Thermostat Adapter into the jack on the bottom of your thermostat
The green LED will turn on
Un-Install
1) Open the front “cover” of the thermostat by gently pulling the right edge of the cover towards you
2) While pressing firmly on the small round button (center, bottom of thermostat) pull down gently on the INSTEON Thermostat Adapter
The INSTEON Thermostat Adapter will disconnect from the thermostat
Adding your Thermostat Adapter to a Scene on your INSTEON Compatible Controller
For example, let’s say you would like to remotely control your thermostat to 73 degrees, heat mode from the comfort and convenience of your
couch, using the Scene A button on your RemoteLinc™ (If you want to use another INSTEON Compatible Controller, see its user manual)
1) Tap the mode button on your thermostat until the mode indicated is heat
2) Tap the up and/or down arrows on your thermostat until the temperature set point is 73 degrees
3) Press & hold the top of the Scene A button on your RemoteLinc (for about 10 seconds) until it beeps
The LED will start blinking (Press & hold for 10 seconds works for just about every INSTEON compatible Controller.
Please check your Controller’s owner’s manual if you need help)
4) Press & hold the button on the INSTEON Thermostat Adapter (for about 5 seconds)
The LCD display on your thermostat will briefly display all its characters, then return to normal
The INSTEON Adapter’s LED will blink off faintly, then return to steady on
The RemoteLinc will beep and its LED will stop blinking
5) Tap the mode button on your thermostat (this will temporarily change the operating mode to allow you to test your remote control)
Your thermostat’s mode will change to cool
6) Tap the Scene A (up arrow) on your RemoteLinc
Your thermostat should return to heat mode with a 73-degree set point
Button
LED