User's Manual
RemoteLinc 2 Rev. 2/16/2012 3:28 PM / See Owners Manual for Warranty Information, Patented
© Copyright 2012, Smarthome, 16542 Millikan Ave., Irvine, CA 92606, 800-762-7845
Status LED
Set button
Micro-USB
Charging
Jack
Powe
r
Switch
(Left Off,
Right On)
Quick-Start Guide
RemoteLinc
™
2 - INSTEON
®
Wireless Controller
Model: 2342-2
Model: 2342-3
Introduction
Use the power of INSTEON to control your home with the convenience of
a compact and versatile wireless controller.
What's Included
RemoteLinc 2
Getting Started
It is recommended that you fully charge your RemoteLinc 2 prior to
programming. RemoteLinc 2 charges via a USB cable (Type A to Micro-B,
sold separately). The red charging LED will turn off once the battery has
been fully charged.
To turn on RemoteLinc 2, simpl
y
slide the power switch to the on position.
Using RemoteLinc 2
RemoteLinc 2 contains four on/off button pairs. Each pair controls its own scene, sending commands to devices
linked specifically to the on/off button pair. Dimmable responders may behave differently, depending on whether
you tap, double-tap, or press & hold a button to activate/deactivate a scene. Non-dimming responders will only
turn full-on or full-off, no matter what method you use.
Tap Double-tap Press & hold
Ramp to on-Level or off Full-bright or full-off
instantly
Brighten or dim until
released
The RemoteLinc 2 Status LED will flash GREEN once for each ON/BRIGHT command
sent and RED once for each OFF/DIM command sent
Warning: RemoteLinc 2 is permanently sealed. Do not attempt to open case. Doing so will damage the remote.
Add RemoteLinc 2 (Button) to a Scene as a Controller
1) Tap on "^" on the RemoteLinc 2 scene button of choice
2) Adjust the responder to the "state" you want when the scene is activated from RemoteLinc 2
1
3) Press & hold RemoteLinc 2's Set button until the RemoteLinc 2 beeps
RemoteLinc 2’s LED will begin blinking GREEN
4) Press & hold the responder’s Set button until the responder beeps (or until LED/Load flashes)
RemoteLinc 2 will double-beep and its LED will stop blinking
Responder’s LED will stop blinking (it may also double-beep)
5) Confirm that scene addition was successful by tapping on/off on your chosen RemoteLinc 2 button
The responder will toggle between the scene on level and off
1
If the responder is a multi-scene device, tap the Scene button you wish to control until it's LED is in the desired state (on or off)
Scene
Buttons
(Left Off,
Right On)
Charging
LED