User's Manual

Instructions for Chime Wireless ( Model no.WC815L, WC532L, WC533L,

WC805L)

1. Use a small screwdriver to open the cover of transmitter. Insert the supplied 1pc 3V

CR2032 button cell with positive (+) up, observe polarity.

2. Locate a good position for the pushbutton next to the door. Do not mount on or next to a

metal surface. Drill two 4.76mm holes and insert the wall plugs. Place the back plate in the

right position and tighten the plate on wall with the screws (2.6 x 26mm BA type) supplied.

Close the cover.

3. Open the battery door of chime receiver, insert 3pcs 1.5V “D” cell battery in the chime,

observe polarity.

4. Press “Learn” button ( symbol ) once on receiver (see fig.1). The LED light up,

it indicates the receiver is in learn mode process.

5. Press the transmitter once, and you will hear the melody from chime receiver. This

indicates the receiver is learning the signal from transmitter properly. Press the transmitter

to hear the built-in melodies in the receiver. Stop pressing the transmitter when you hear

the desire melody. There are total 16 different melodies for selection.

- Westminster

- Ding Dong

- Ding Dong Ding

- Tubular 1

- Orchestra

- Tubular 2

- Trumpet

- Dog Barking

- Mirage

- Bird

- Pang

- So me do

- Knock Knock

- Cuckoo

- Old phone

- Buzzer

6. After that, press again “learn” button on the receiver, the LED light off and the receiver exit

the learn mode.

Or, just wait approx. 20secs, the LED light off and the receiver will exit the learn mode

automatically.

PAGE 1
Instructions for Chime Wireless WC805L) ( Model no.WC815L, WC532L, WC533L, 1. Use a small screwdriver to open the cover of transmitter. Insert the supplied 1pc 3V CR2032 button cell with positive (+) up, observe polarity. 2. Locate a good position for the pushbutton next to the door. Do not mount on or next to a metal surface. Drill two 4.76mm holes and insert the wall plugs. Place the back plate in the right position and tighten the plate on wall with the screws (2.6 x 26mm BA type) supplied.
PAGE 2
7. Press the transmitter, the receiver will sound the melody selected. 8. There are 4 selectable volume level, press “Volume” button ( symbol ) on the receiver. (See fig.1) to select the desire volume. 9. Receiver can learn up to 4pcs of transmitter. Repeat the above step.4, 5, 6, 7. 10. Locate the chime receiver within the working range 300ft. 11. It is possible to erase all learned transmitters. Press & hold the “learn” button on the receiver approx. 15secs until LED light off.
PAGE 3
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:  Reorient or relocate the receiving antenna.  Increase the separation between the equipment and receiver.