SmartCrop® Sensors Installation Guide Only Smartfield™trained and certified installers are authorized to install and maintain equipment.
Copyright © 2010 SmartfieldTM, Inc. All rights reserved. No part of this document may be reproduced or transmitted in any form or by any means electronic or mechanical, for any purpose without the express written permission of SmartfieldTM, Inc. Information in this document is subject to change without prior notice. Certain names of program products and company names used in this document might be registered trademarks or trademarks owned by other entities. SMARTFIELD, INC.
. Guidebook Conventions To highlight the most important points – we have used a set of simple icons, which draw attention to key information and settings. Key: The Check Icon indicates a setting that we recommend you use or enable. The Info Icon highlights important facts and information about SmartCrop® Sensors, to help you make better use of the product. The Hazard Icon highlights areas where potential problems can arise Sensor battery install a.
7. Scroll down using the “Down” arrow and highlight “Finished” and press “Enter” once, scroll down on the second screen and select “Finished” again, and press “Enter” to go back to home screen. Figure 4: Base Station – serial number: xxxxl. “Finished” located at the bottom of the display. S martfield One (1) Year Limited Warranty Smartfield’s warranty obligations for these hardware products are limited to the terms set forth below: Smartfield, Inc.