Quick Start Instructions

Program Your Replacement Pad/Mat to 433-EC
ENTER PROGRAMMING MODE: Use a paperclip or a pointed
tool to press and hold the “Program” button within the hole
on the back of the monitor, located under “Program”. When
the outer two LED Lights on the front of the monitor are solid,
release pressure on the button. The lights will remain on to
indicate that the monitor is in programming mode.
1
PROGRAM DESIRED COMPONENTS:
*Have components ready before starting
CordLess Sensor Pads/Mats: The transmitter must already be
connected to a sensor pad and turned on. Place pressure on the
sensor pad/mat and then release.
Maximum Range: Up to 300 feet.
*If programming multiple components, repeat step 1
until all components have been programmed & continue
to step 3 to exit programming.
EXIT PROGRAMMING MODE: Once the programming is
complete, press and release the program button on the back
of the monitor. The outer two LED lights will blink to conrm
programming and turn o.
2
3
IMPORTANT INFORMATION: This wireless device and compatible components rely on wireless technology
which is subject to physical and environmental considerations. These products do not have an out of range
function and as such should be tested periodically in the setting in which they are to be used to understand
their area of e ective operation. Please be aware that the transmitter will not be 100% accurate if it is out of
range at anytime. Wireless systems and monitors are intended as an adjunct to good care giving practices
and are not a substitute for proper sta ng and patient management practices. We recommend that all
personnel receive periodic training in the operation of these systems and that the systems are tested before
each use.
WARNING: Failure to comply with warning may result in injury or death. This device is not suitable for all
individuals. Other devices may be required. This device is not substitute for direct visual monitoring by
a caregiver. The manufacturer does not claim that this device will stop elopement and/or stop falls. This
device is designed to augment caregivers’ comprehensive resident mobility management program. Read
the instructions and legal disclaimer. The Smart Caregiver Corporation wireless device is designed to be
installed by the end-user. As such, it is the entire responsibility of the buyer to verify that Smart CordLess
products are properly installed and tested successfully, before each use, in the setting in which they are to be
used. Further, the system is not designed to replace good care giving practices including, but not limited to:
A.) Direct patient supervision
B.) Adequate training for sta personnel in fall management and elopement.
C.) Testing of the system before each use.
DC6~12V
OFF CHIME
HI MED LOW
PROGRAM
433-EC
Artwork: 433-EC
Revised: 8-19-15
Low
Battery
Quick Start Instructions
Low
Battery
CordLess
Caregiver Alert Monitor
Floor Mat
Transmitter
Bed Pad
Chair Pad
Follow
us on:
NEW PAD
DESIGN