25 Code GTO Digital Keypad Instructions for Wired and Wireless Installations Thank you for purchasing the G0 Digital Keypad. Be sure to read the directions carefully and completely. Before permanently mounting the keypad, please program the keypad and test its range. IMPORTANT: Your keypad ay need to be Hurd wired due to the fact that it must accept interference according to FCC reputations listed below. For example.
Keypad Description Keypad Front PROGRAM button: Used to program aces codes, STATUS Light: This led will blink once when any key is pressed und provides visual feedback during access code programming, Installing Batteries NOTE: 3 AA batteries arc required to parer the keypad unless an external power supply such as the gate openers power source is used. Low voltage wire from the external power source must be connected to the POWER IN terminals on the keypad control board, if butteries are not installed.
Step To wire the power supply to the keypad attach the wires to the AC/DC POWER IN terminated-wire the keypad black marked RELAY OUTPUT other end 10 the opener’s control board as shown in Control Gourd on the k nal on the keypad control board as shown to the right. Connect the other end to the openers battery one end ta the POSITIVE pole and the other to the NEGATIVE pale.
Programming the Keypad Programming Interface: Program (Add) New Temporary Entry Case: All codes are four (4) digits in length. Entry code is a four (4) digit aced needed t activate the gate, Master Code is needed to add, remove or reset entry codes.
Delete ALL Entry Codes: v Pre and defense PROGRAM button er the Master Case then press and release PROGRAM button « Banter), 7 then press and release PROGRAM button, + Beeper beeps 3 times to confirm that the All Penury Codes are deleted. Example: Key press sequence to delete all entry codes from memory. (3121 is the Master Case) eiizi3dell7e The round black dot is the ‘PROGRAM bunion.