Model: P-220 INC. Instructions for Gate Operator Radio Controls: Single Entry Transmitter, Key chain Mini Transmitter, Dual& Triple Entry Transmitters Read the following instructions thoroughly before using transmitter. CODE. IT MUST BE CHANGED TO SAFEGUARD AGAINST CAUTION: EACH TRANSMITTER 1S SET TO A FACTORY PRESET | UNAUTHORIZED OR UNWANTED OPERATION. J FCC Regulation: This device complies with FCC Rules Part 15.
NOTE: Be sure the red light on the transmitter is bright and stays on while waiting for the control hoard to return to the operating mode. If the red light is dim or flickering, the transmitter battery may be weak. Replace when necessary with a nine (9) Volt battery. 4. Using your transmitter The transmitter can either be hand held or mounted on the sun visor of your vehicle with the enclosed visor clip. If sun visor mounting is desired, slide the visor clip into place on the back of the transmitter.
t i i INSTRUCTIONS FOR DUAL AND TRIPLE TRANSMITTERS The two and three button transmitters are used for the Figure A remote control of two. or three gate openers and/or garage door openers (Figure A). TO PROGRAM FOR USE WITH GATE OPERATOR: 1. Remove the Transmitter Cover Remove the access cover from the front of the transmitter by sliding the cover away from the top of the transmitter. This will expose the battery and the dip switches. The code can now be changed using a small screwdriver. 2.
2. Remove the Garage Door Receiver Cover Use a small screwdriver or knife © remove small door on back of receiver to gain access to coding switches (Figure C). 3. Setting the Code "In the transmitter there are eight {8) dip switches, each of which can be placed in three different positions DO NOT set all switches in the same position, such as all +, all -, or all zeros. WARNING: No other adjustments should be made inside the transmitter. Figure D In the receiver, there are nine (9) dip Trans switches.