ne. Instructions for Gate Operator Sadie Control Single Entry Transmitter Read the following instructions thoroughly before using transmitter. CAUTION: Each transmitter is set to a factory preset code. I must be changed to safeguard against unauthorized or unwanted operation. INSTRUCTIONS FOR SINGLE BUTTON TRANSMITTER Re wave the Transmitter Cover Open the transmitter by removing the (wo screws on cache side of the spring clip on the hack of the transmitter, This will expose the battery und the.
neighbor. WE Amt re 4. Using your transmitter | on gate opener control board The transmitter can either be hand held or mounted on the sun visor of your vehicle. To activate your gate operator, simply depress your transmitter button until the gate begins to move. NOTE: If the red light on the transmitter is dim or flickers when the transmitter button is pushed, the transmitter battery may be weak. Replace when necessary with a A238 12 Volt battery.
INSTRUCTIONS FOR DUAL BUTTON TRANSMITTERS “Fhe two button transmitter fs used for the remote control of 1a gate openers or 4 ate opener and # garage door opener, 1.