User Instructions

ManualsBrandsSmart Foal ManualsAlarm SystemsSmart Foal Foaling Alarm System Repeater

Congratulations and thank you for purchasing your new Smart

Foal Repeater!

What’s in the box?

1 x Repeater

2 x Antenna

1 x Power pack

1 x instructions

Setup:

The Smart Foal Repeater is very simple to use. It is essentially plug-n-play. It’s job is to pick

up signals from your mares and relay the signal back to your house/WiFi Base station.

1. Attach the antennas to the Repeater

The antennas have a simple screw thread. Turn until the antenna

feels firmly attached.

2 x Antennas

Repeater

Power pack

Summary of content (5 pages)

PAGE 1
Congratulations and thank you for purchasing your new Smart Foal Repeater! What’s in the box? 1 x Repeater 2 x Antenna 1 x Power pack Repeater Power pack 1 x instructions 2 x Antennas Setup: The Smart Foal Repeater is very simple to use. It is essentially plug-n-play. It’s job is to pick up signals from your mares and relay the signal back to your house/WiFi Base station. 1. Attach the antennas to the Repeater The antennas have a simple screw thread. Turn until the antenna feels firmly attached.
PAGE 2
. Plug in the power cord Remove the dust cap then insert the power cable. 3. Turn the Repeater on To turn on the Repeater press the switch on the side of the box. The light inside the switch will come on. 4. To turn the Repeater off, press the switch again. The light will turn off. That’s all there is to it. The Repeater will connect to, and repeat, the signal from any transmitter within range automatically. You don’t need to do anything to make it happen.
PAGE 3
WiFi Base station side antenna Mare side antenna
PAGE 4
Each antenna serves a purpose. The Receive Antenna (Mare side) talks to the transmitters mounted on the mares. The Transmit Antenna ONLY talks to the WiFi Base station. Position or rotate your Repeater so that the mares are mostly on the Receive Antenna side of the Repeater, and the WiFi Base station is on the Transmit Antenna side. The Repeater can be powered by the power supply in the box, a car battery or a solar panel.
PAGE 5
Radio Notice: FCC ID: 2AWQP-RPH20 This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC Rules.