User's Manual

Dual High Performance Motors!
Super Grip Knobby Tread!
AGES 8 +
Radical
Jumps!
Thrilling
360s!
Hyper
Speed!
Radical
Jumps!
Thrilling
360s!
Hyper
Speed!
Radical
Jumps!
Thrilling 360s! Hyper Speed!
Radical Jumps!
Thrilling 360s! Hyper Speed!
both sticks forward
Extreme Speed:
both sticks back
Reverse:
right stick forward
Left Turn:
left stick forward
Right Turn:
right stick forward, left stick back
360º Anti-clockwise Spin:
left stick forward, right stick back
360º Clockwise Spin:
The radio Controller gives you com-
plete control in the palm of your
hands - from super speeds to awe-
some stunts!
Requires 6.0V rechargeable NiCd battery (MotorBall) and 9V battery (Controller). Batteries included.
Do tricks like no other R/C in the world!
AGES 8 +
The World’s FIRST Radio Control Ball!
Requires 6.0V rechargeable NiMH battery
(MotorBall) and 9V battery (Controller).
Batteries included.
Requires 6.0V rechargeable NiMH battery
(MotorBall) and 9V battery (Controller).
Batteries included.
Race other MotorBalls or any R/C vehicle
using a different frequency!
Channel 1
Yellow
Channel 1
Yellow
Channel 2
Orange
Channel 2
Orange
Channel 1
Yellow
Channel 1
Yellow
Channel 2
Orange
Channel 2
Orange
Channel 1
Yellow
Channel 1
Yellow
Channel 2
Orange
Channel 2
Orange
Race other MotorBalls or any R/C vehicle
using a different frequency!
Get on a roll that you control! Hyper speed, soaring jumps and radical 360s make this the ultimate R/C for racing and free-styling fun!
Stabilizer Wheel
Antenna
Super Grip Knobby Tread
Twin, Ultra-Blast Motors!
Do not operate during thunderstorm or rain.
Avoid water, sand and snow when operating your ball.
Do not submerge ball or controller in water.
Never operate your ball on the street or highway.
Adult supervision is recommended when operating this ball.
Remove all batteries when not in use to avoid accidental operation.
Never operate your ball in a confined or crowded area, and do not
use people or animals as obstacles.
Do not run your ball into furniture, objects or hard surfaces, as this will
cause damage to both the objects and the ball.
Keep fingers, hair and loose clothing away from the tires, gears and motor
while the ball is switched to “ON”.
Do not leave ball or controller near sources of heat or under direct sunlight
for long periods of time.
Do not leave ball or controller outside overnight.
Dampness is harmful to interior components.
transformer or charging unit used with the toy are to be regularly examined for
damage to the cord, plug, enclosure and other parts, and that, in the event of
such damage, the toy must not be used with this transformer until the damage has
been repaired.
SAFETY PRECAUTIONS
CAUTION: After first 2 times usage, do not charge the
battery for more than 8 hours, overcharging will damage it.
HOW TO CHARGE THE BATTERY
TO PROLONG YOUR BATTERY’S LIFE
• Always use up the battery charge completely before charging it again.
Charging the battery for more than 4 hours will not provide a longer time
of use; 4 hours is the time it takes to fully charge the battery. The life of
the battery depends on how you use your ball and the tricks you perform.
• Let the battery cool for around 20 minutes before charging it again. Never
recharge a battery if it is warm or hot.
• Connect the wall charger to a standard AC outlet.
• Insert the battery in the charger.
• Make sure the light turns on; this indicates the battery is being charged.
• Let the battery charge for 8 hours the first 2 times you use it.
After that, it will only require a charge of 4 hours.
• The battery will be hot; this is a normal characteristic when it is fully charged.
• When the battery is fully charged, disconnect the charger from AC outlet
press the red button at the front of the charger and slide the battery downward
at the same time to remove it.
• Disconnect the charger from the outlet when you are not using it.
NOTE:
You must charge the
rechargeable battery
at least 8 hours the
first 2 times before
using it.
BATTERY INFORMATION
• Alkaline batteries recommended for controller.
• Do not use rechargeable batteries for controller.
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are to be removed from the toy before being charged.
• Rechargeable batteries are only to be charged under adult supervision.
• Different types of batteries or new and used batteries are not to be mixed.
• Only batteries of the same or equivalent type as recommended are to be used.
• Batteries should be replaced by an adult.
• Batteries are to be inserted with the correct polarity.
• Exhausted batteries are to be removed from the toy.
• The supply terminals are not to be short-circuited.
• Batteries are to be removed from the product when not in use.
• Do not dispose of batteries in fire.
• Please retain this instruction since it contains important information.
• Not suitable for children under 36 months due to small parts.
• Contents and colors may vary as shown.
6.0 V rechargeable
NiMH Battery
9 V Battery
OFF / ON
switch
CLOSE
OPEN
CLOSE
OPEN
Rollin’ Radio Controllin’ Action!
Rollin’ Radio Controllin’ Action!
Rollin’ Radio Controllin’ Action!
Rollin’ Radio Controllin’ Action!
Rollin’ Radio Controllin’ Action!
Rollin’ Radio Controllin’ Action!
MANUFACTURED BY SCS:
RM 2105-8, 21/F, GREENFIELD TOWER (SOUTH),
CONCORDIA PLAZA, NO. 1 SCIENCE MUSEUM ROAD,
TSIM SHA TSUI EAST, KOWLOON, HONG KONG.
TEL.: [phone] - FAX: [phone]
MADE IN CHINA.
The operation requires 6V rechargeable battery pack (included) for ball
and one 9V battery (included) for controller.
Carefully remove items from package.
Position the ball so that the on/off switch is facing you.
Use a screw driver to open the ball and insert a fully charged battery pack into the
compartment, the battery will snap into place and be secured by the locking clip
locking clip located on the roof of the battery compartment.
Replace the ball compartment door. And fasten the screw.
Use a screw driver to open the battery compartment on the back of the controller.
Insert the 9V battery following the correct polarities.
Replace the battery compartment door. And fasten the screw.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
o Reorient or relocate the receiving antenna.
o Increase the separation between the equipment and receiver.
o Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
o Consult the dealer or an experienced radio/TV technician for help.
1649-001-01
L45XD22XH26cm
Color: CMYK+Diecut
18MAY09