Installation Manual DVR4X4 4-port DVI-D Matrix Switch with RS-232, IR, USB and TCP/IP Control (optional) Display Content From Any 4 Computers On Any 4 Screens Independently Up To 30 Feet Away www.smartavi.
Introduction What’s in the Box? SmartAVI’s non-blocking DVR4X4 digital video matrix switch provides an easy and dynamic approach to switching the DVI output from up to 4 computers, to up to 4 displays. The switching can be controlled directly via the front panel, or remotely using RS-232 commands, IR, USB or TCP/IP (optional). The DVR4X4 is controlled by Windows®-based software that is easy to understand and simple to use – a cornerstone of all SmartAVI products.
Installation COMPUTERS DVI-D DISPLAYS 30 ft. over DVI-D 30 ft. over DVI-D Connecting the DVR4X4 1. Power off the computers and displays. 2. Connect the DVI video cables from the computers to the DVI-D inputs on the rear of the DVR4X4. 3. Connect the DVI displays to the DVI-D outputs on the rear of the DVR4X4. 4. Power on the DVR4X4. 5. Power on the computers and displays. 4 www.smartavi.com DVR4X4 30 ft.
Flexible Control Options DDC Learning Switching Between Ports DDC provides plug-and-play capability to your displays. When you plug a display into your computer, the DDC table in the display tells the computer the optimal resolution to use. In order to preserve this plug-and-play capability, we have integrated DDC learning into all of our DVI Solutions.
Flexible Control Options (Continued) Software Installation & Operation There are 3 other ways to control your DVR4X4: Find the Installation CD that came with your DVR4X4 unit. This CD has the SmartControl software that you will need in order to control the unit using a computer. Insert the CD into your CD-ROM. On the CD you should see: SmartControl Installer.exe SmartControl Help File DVR 4X4 Manual in PDF format Double click SmartControl.exe in order to initiate software installation. Click Install.
Software Installation & Operation (Continued) The Main Routing Window enables you to control the router(s) connections by means of the matrix panel, the button panel, or with pre-recorded routes called macros. Matrix Panel: This is probably the simplest way to route the connections. Simply click on the cross point itself. The input on the left will then be routed to the output above. Note: Inputs can be routed to several different outputs, but each output can only have a single input at any one time.
Software Installation & Operation (Continued) RS-232 Specifications How to properly create an RS-232 connection between a PC and most SmartAVI RS-232 compliant devices Establish a connection to your RS-232 compliant device: 1. 2. 3. Smartcontrol Pro is based on RS232 queries with CRC protocol, any software that can send hex or ascii code can control the SuperMatrix. Each box is called a frame and have a special number sending Audio/Video from any source to any remote.
5) To query crosspoints from PC: //FxxU • If all outputs are connected to input 1 then a 4x4 Matrix will respond with <0x80><0x80><0x80><0x80> • The router will send back one byte for each output and the string ends with a . The first byte sent is Output #1. In the example above, since there are 5 bytes total, we know that there are 4 outputs. • To calculate the input number, the router sends the input number with the 7th bit set.
SmartAVI, Inc. / Twitter: smartavi 11651 Vanowen St. North Hollywood, CA 91605 Tel: (818) 503-6200 Fax: (818) 503-6208 http://www.SmartAVI.com www.smartavi.