Installation Instructions

AES
GmbH
-
D
-
99310
-
Arnstadt
-
Markt 14
-
+49
-
3628
-
78300
-
www.ibri
-
aes.com
Multi Frequency Reader SA2
-
CAN
-
V
3
RFID frequency 13.56 MHz 125 kHz
RFID protocol ISO 14443a all typical tags (extendable)
ISO 15693
Interface CAN
Operating voltage range 8...60 V
Max. operating voltage 72V
Max. power consumption 135 mW
CAN bus speed 125 kbit/s
500 kbit/s
Temperature range -30...+70 °C
The reader supports the two main frequencies for
RFID cards. At the low frequency 125 kHz, a wide
range of available transponders are read. At the high
frequency 13.56 MHz, the standards ISO14443a
and ISO15693 are implemented. NFC devices are
detected. The readable card range can be extended.
The reader implements the physical interface to the
CAN bus. Two LED’s indicate the acceptance or
rejection of the card.
The application areas
of the rugged industrial
reader can be used wherever transponder cards must be identified.
Such identification systems can launch vehicles, provide access free or allow other authorization or prohibit. The UID
of authorized cards are stored in the device. The release takes place by means of a command on the CAN-bus. The
reader can be trained with the help of a “TeachOn”-card. To store the UID’s at the “TeachOn”-card there exist a MTR-
reader with an USB HID connection to the PC. The user programs the UID's on the reader using a convenient PC
program. When the device is turned on the reader starts with the protocol of the “TeachOn”-card to configure the
reader. The firmware can be convenient updated via the CAN bus in the field.
The power supply comes maybe from vehicle batteries 12, 24 or 48V. Surges voltages as they occur during braking
are tolerated. For self-protection the device has internal suppressor diode triggers, when crossing the threshold
voltage of approximately 70V, a resettable fuse. The unit has reverse polarity protection against installation errors.
AES GmbH phone [phone] [e-mail]
Markt 14 www.ibri-aes.com
D-99310 Arnstadt
Germany