Order Number : GETEC-C1-19-481 FCC Part 18 Test Report Number : GETEC-E3-19-027 Page 1 / 1 APPENDIX H : USER’S MANUAL EUT Type: Wireless Charger FCC ID.
1. Application A system that receives the battery voltage in the ACC ON state of the vehicle and drives the wireless charging system to transmit power to the target cellular phone with an output of 5W. Can be used with Qi certified internal mobile phone or wireless charging exclusive accessory case. 24.5mm ◈ Connect the wireless charging module at the top of the console 72.8mm Front. View 80.2mm ISO. View 147.8mm • Application method : Magnetic induction (5W) • Module size : 80.2mm x 147.8mm x 23.
2. User manual Wireless charging module Main Connector MG645877(KET社) No.
2. User manual Single Item Wireless Charging Module Operating Conditions 1) Power line connection : No.1,2 Pin(12V), No.12 Pin(GND) 2) Power supply 3) If you put a wireless rechargeable mobile phone on top of the charger Actual car wireless charging module operating condition 1 2 ▣ How it works 1. Close all doors of the vehicle 2. Switch the vehicle's power to ACC or higher 3. Put a wireless rechargeable cell phone on the tray ▣ Development and Results 1.
3. RF Specification Frequency Number of Hopping Channel Spread Type (확산방식) Modulation Type (변조방식) Ocillation Type (발진방식) Power [dBm] Sensitivity [dBm] NA (No oscillation) 5Watt (36.9dBm) NA (Transmitter) 110kHz±5kHz NA (Do net use Hopping) NA (No Spreading) NA (Only receive Modulated packet From Receiver, Transmitter does not modulate) Data rate (전송속도) Channel Spacing (채널 대역폭) 전원 설비 Standard (기반규격) 통신 방식 Applications NA (Receiver side Data rate is 2kbps) NA (No Channel) 13.
4. Operation description Item Contents Rated voltage DC 13.5V Operating voltage DC 9V~16V Operating temperature Operating temperature of wireless charger system : -30℃ ~ +70℃ Operating temperature of mobile phone : 0℃ ~ +35℃ Output power 5W(5V, 1A) Output frequency 110kHz±5kHz Input power source This wireless charger should be supply by limited power sources.
5. Compliance Statement Regulatory Compliance IMPORTANT NOTE: FCC Compliance statement This device complies with part 18 of the FCC Rules. IMPORTANT NOTE: FCC RF exposure statement This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. This equipment should be installed and operated with a minimum distance of 20 cm (7.