User Manual

MODEL SKY6016 TRIPOD/BASE MOUNT

Warning: Do not use with mount pipe longer than 18"

1. FIRST TIME ASSEMBLY: Attach adjustment knob using the square nut and nut clamp. Turn

base upside down. Place nut inside nut clamp and drop into slot on bottom of base so that the

open side of the nut clamp is toward the flat side of the base. Screw in adjustment knob. Use

this knob to remove and re-tighten pipe mount for travel or storage.

2. Attach compass to base, secure level to base.

3. Attach rubber feet to support legs.

4. Insert spring clips into the support legs until locked in place.

5. Slide legs into base until locked in place.

Square Nut and Nut Clamp

Adjustment Knob

18in Pipe Mount

Bubble Level Compass

Base

Spring Clip

Support Leg

Rubber Foot

Elastic Cord

Anchor Screw

PAGE 1
MODEL SKY6016 TRIPOD/BASE MOUNT Warning: Do not use with mount pipe longer than 18" 1. FIRST TIME ASSEMBLY: Attach adjustment knob using the square nut and nut clamp. Turn base upside down. Place nut inside nut clamp and drop into slot on bottom of base so that the open side of the nut clamp is toward the flat side of the base. Screw in adjustment knob. Use this knob to remove and re-tighten pipe mount for travel or storage. 2. Attach compass to base, secure level to base. 3.
PAGE 2
OPERATION: 1. Turn satellite receiver on, and use installation menu to determine the azimuth and elevation for your location. 2. Remove the compass from the mount. The metal pipe and antenna will effect compass operation. Using the compass, determine the best location for the mount. NOTE: Satellite signals will not go through trees, buildings, etc. 3. Screw anchor into the ground. TIP: Use a large screwdriver or piece of pipe inserted into the top loop to help screw anchor into ground. 4.