User Guide

ManualsBrandsSkyTech ManualsAccessories & SuppliesSkytech 1001-A Fireplace Remote Control On/Off

MODEL: 1001 - A

INSTALLATION AND OPERATION INSTRUCTIONS

IF YOU CANNOT READ OR UNDERSTAND THESE INSTALLATION INSTRUCTIONS DO

NOT ATTEMPT TO INSTALL OR OPERATE

INTRODUCTION

The transmitter operates on a 12V (A23) battery that is included. Install the 12V battery sup-

plied with the unit into the battery compartment. It is recommended that ALKALINE batteries

always be used for this product. Be sure the batteries are installed with the (+) and (-)

ends facing the correct direction.

The LED signal light should illuminate when either the ON or OFF button is pressed. If the

signal light does not illuminate, check the position of the transmitter’s battery, and if the bat-

tery is fully charged.

TRANSMITTER

REV 4/15/11 Page 1

This remote control system was developed to provide safe, reliable, user-friendly remote control system for gas heating appliances. The

system can be operated manually from the transmitter.

OFF

FRONTBACK

SIGNAL

LIGHT

ON/OFF

BUTTONS

BAT TERY

COMPARTMENT

RECEIVER

Install the (4) AA-size batteries supplied with the unit. It is recommended that ALKALINE batteries always be used for this product. Be

sure the batteries are installed with the (+) and (-) ends facing the correct direction.

ON• : will manually turn on the appliance.

REMOTE• : will allow use of handheld transmitter. If the system does not respond

to the transmitter on initial use, check the battery positions in the remote. If that

does not work, see the SECURITY CODE section.

OFF• : will disable the remote receiver.

It is suggested that the slide switch be placed in the OFF position if you will •

be away from your home for an extended period of time.

REMOTE

OFF

LEARN

Requires 4-AA 1.5V

alkaline batteries

Learning

button

Remote Receiver

Battery cover slides on/off

Slide

Switch

REMOTE

OFF

The remote receiver has a 3-position slide switch for selecting the mode of operation

ON/REMOTE/OFF

Skytech 1001-A

Summary of content (6 pages)

PAGE 1
MODEL: 1001 - A INSTALLATION AND OPERATION INSTRUCTIONS IF YOU CANNOT READ OR UNDERSTAND THESE INSTALLATION INSTRUCTIONS DO NOT ATTEMPT TO INSTALL OR OPERATE INTRODUCTION This remote control system was developed to provide safe, reliable, user-friendly remote control system for gas heating appliances. The system can be operated manually from the transmitter. TRANSMITTER SIGNAL LIGHT ON ON/OFF BUTTONS OFF The transmitter operates on a 12V (A23) battery that is included.
PAGE 2
WARNING This remote control system must be installed exactly as outlined in these instructions. Read all instructions completely before attempting installation. Follow instructions carefully during installation. Any modifications of this remote control or any of its components will void the warranty and may pose a fire hazard. Do not connect any gas valve or electronic module directly to 110-120VAC power.
PAGE 3
WIRING INSTRUCTIONS A qualified electrician should install the remote control system. WIRING MILLIVOLT VALVES TERMINAL BLOCK ON MILLIVOLT GAS VALVES TH TP TP • TH • Connect one wire from the remote receiver to the TH terminal on the gas valve. Connect the other wire from the remote receiver to the TH/TP terminal on the gas valve. THERMOPILE/ PILOT LIGHT REMOTE RECEIVER MILLIVOLT SYSTEM CHECK • • • • Ensure that the pilot flame is lit.
PAGE 4
TRANSMITTER WALL CLIP The transmitter can be hung on a wall using the clip provided. • Wood - Drill 1/8’’ pilot holes and install with screws provided. • Plaster/Wallboard - Drill 1/4’’ holes, use a hammer to tap in the two plastic anchors, then install with the screws provided. WALL CLIP SLOT WALL CLIP BATTERY COMPARTMENT BATTERY LIFE Life expectancy of the alkaline batteries in the transmitter and receiver should be at least 12 months. Check and replace all batteries: • Annually.
PAGE 5
Limited Lifetime Warranty SKYTECH II warrants the SKYTECH REMOTE CONTROL SYSTEM for a Limited Lifetime of the original owner of this system. This warranty is not transferable to another person it is for the original purchaser of the product. Should any part fail because of defective workmanship or material from the original date of purchase. SKYTECH II will repair or, at SKYTECH II option, replace the defective parts.
PAGE 6
Santa’s Helper Exclusive offer to Skytech Remote Control Owners This special offer is only provided to customers of Skytech II, Inc. that have purchased a remote control for their Hearth Product. This remote control system can be used for any 110Volt appliance, but perfect your Christmas Tree Lights or any other appliance that is difficult to reach or plug in. Simply plug the receiver into your wall outlet and your appliance into the receiver, push the ON button on the transmitter and you are in business.