User's Manual

RCAF-1030 主機操作說明

遙控功能:

1．裝入 4 個 AA 電池。

2．確實將滑動開關切至 Remote

3．按下 Learn 鍵﹐ 一長 Beep﹐此時主機進入學習模式。

4．發射器按 On﹐ 主機連續 Beeb 5 次標示學習成功。

手動開關:

1. 裝入電池後將滑動開關切至 ON 或 OFF。

Remote Function:

1. Install 4*AA batteries.

2. make sure sliding switch is positioned at Remote

3. Press Learn button, unit enters learning mode after one long beep

4. Press On key on the remote, Rx will alarm 5 beeps indicating learning complete.

Manual On/Off

1. Move the sliding switch to On/Off for activation or turn the unit off.

FCC Compliance Statement:

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference

that may cause undesired operation.

Notice 15.21

Changes or modifications not expressly approved by the party responsible

for compliance could void the user's authority to operate the equipment.

PAGE 1
RCAF-1030 主機操作說明遙控功能: 1．裝入 4 個 AA 電池。 2．確實將滑動開關切至 Remote 3．按下 Learn 鍵﹐ 一長 Beep﹐此時主機進入學習模式。 4．發射器按 On﹐ 主機連續 Beeb 5 次標示學習成功。手動開關: 1. 裝入電池後將滑動開關切至 ON 或 OFF。 Remote Function: 1. 2. 3. 4. Install 4*AA batteries. make sure sliding switch is positioned at Remote Press Learn button, unit enters learning mode after one long beep Press On key on the remote, Rx will alarm 5 beeps indicating learning complete. Manual On/Off 1. Move the sliding switch to On/Off for activation or turn the unit off.