User's Manual

ManualsBrandsSkyrocket Toys ManualsElectronicsSky Viper Nano Quad

™

200

#skyviper#skyviper

www.skyrockettoys.com/products/sky-viper

Customer Service :

888-674-5650

Sky Viper is a registered tradmark and the Skyrocket logo are trademarks of Skyrocket Toys LLC.

MADE IN CHINA.

•

Drone may be miscalibrated by launching from an unlevel

surface. Turn the remote off. Turn off the Drone for 30

seconds, then turn them back on and try again from a at,

level launching surface.

•

Ensure your remote is within unobstructed view of Drone and

you are within 30 feet range.

•

Ensure the remote has fresh batteries and the LiPo battery

is fully charged.

•

Inspect Drone for any possible damage. Turn the remote off

and turn off the Drone for 30 seconds then turn them back

on and try again from a at, level launching surface.

•

Drone’s blade may have been installed incorrectly. Reinstall

and remember that the GREEN blades point forward.

•

Adjust the trim controls until drifting ceases, see page 7.

•

Propellers may be installed in the wrong position. Ensure

proper installation.

•

Ensure that Drone is ying a minimum distance of 6 feet

from the ground with a minimum 6 feet clearance in all

directions.

Drone is unresponsive or

behaving erratically

All blades spin, but Drone

will not y properly

Drone drifts in any

direction during ight

without direction from the

remote

Drone crashes

immediately

Drone crashes when

attempting stunt functions

Remove all packaging attachments before giving the toy to a child.

Not suitable for children under 3 years due to small parts that could be swallowed.

Conforms to product safety standards ASTM F963.

Keep instructions for future reference. Do not discard.

This device complies with PART 15 of the FCC Rules. Operation is subject to the following two conditions. (1) This device may not cause

harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

CAUTION: Changes or modications to this unit not expressly approved by the party responsible

for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment

generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If

this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving

antenna - Increase the separation between the equipment and receiver - Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected - Consult the dealer or an experienced radio/TV technician for help.

INSTRUCTION GUIDE

CONTENTS

TROUBLESHOOTING

PROBLEM SOLUTION

RC Nano Drone

Remote Control

4 Replacement Blades

USB Charging Cable

Art Release for Production (Mechanical)

Sky Instructions Domestic

File Name: SV_Nano_Drone_IS_050215_F1.ai

Revision:

Licensor Approval Date:

Production Release Date: 05/02/15

Production Artist: Hanjin Park

Colors: Pantone 294

Trim Size:

Notes:

SIZE: 297 x 210mm (folds to 148.5 x 210mm)

BACK COVER / FRONT COVER

Summary of content (6 pages)

PAGE 1
Art Release for Production (Mechanical) File Name: Revision: Licensor Approval Date: Production Release Date: Production Artist: Colors: Trim Size: Notes: Sky Instructions Domestic SV_Nano_Drone_IS_050215_F1.ai 05/02/15 Hanjin Park Pantone 294 TROUBLESHOOTING PROBLEM Drone is unresponsive or behaving erratically SOLUTION • Drone may be miscalibrated by launching from an unlevel surface. Turn the remote off.
PAGE 2
ADULT SUPERVISION REQUIRED CHANGING DAMAGED PROPELLERS Before each use, an adult should check this product and the LiPo battery to ensure no damage or hazards exist. Drone has rotating blades that move at high speed, posing danger of damage and injury. Pilots are responsible for any actions that result in damage or injury from the improper operation of Drone. Adequate flying space is required. Avoid flying near interior fans and/or vents as they may make flying difficult to control.
PAGE 3
CHARGING & CARING FOR LIPO BATTERY IN THE Drone ONE TOUCH STUNTS BARREL ROLL While flying forward (or reverse), press the STUNT BUTTON. NOTE: Once a stunt has been initiated, DO NOT adjust Throttle or press any other controls until the stunt has been completed). 1 2 FRONT BARREL ROLL REAR BARREL ROLL FLIP 1 Bring the Drone to a mid air hover without flying in any direction. Remove finger from the DIRECTION STICK 2 3 While HOVERING, press and hold the STUNT BUTTON. Turn OFF Remote Control & Drone.
PAGE 4
INSTALLING REMOTE BATTERIES FLYING TIPS Loosen screw in the Remote Control battery compartment door with Philips screw driver and insert batteries as shown. Replace door and tighten screw. • When launching the Drone, face the same direction as the Drone. Green blades and Green LEDs should be in front. + AAA/LR03/R03 1.5V – • Practice launching, hovering and landing before attempting to learn other moves. – AAA/LR03/R03 1.
PAGE 5
FLIGHT SENSITIVITY ADJUSTMENT CALIBRATING & LAUNCHING Drone responsiveness may be adjusted on the Controller to match your flying skills. There are two choices: 1- LOW SENSITIVITY 2– HIGH SENSITIVITY 1 2 It is best to start in the LOW SENSITIVITY position until you have mastered flying. Flight sensitivity can be adjusted before or during flight.
PAGE 6
FLIGHT CONTROLS Familiarize yourself with Drone’s controls before flying! THROTTLE/ROTATION STICK • To make the Nano Drone LIFT, push the Throttle stick FORWARD. • The further you PUSH the Throttle stick, the faster you LIFT. • To make the Nano Drone HOVER, find the sweet spot on the throttle stick (somewhere in the middle).