In Car Audio, ʹ [ek-san-ik]means Sonic Excellence by Mobile Entertainment EXONIC Mobile Entertainment Buena Park,CA. 90621 U. S. A . www.exonicmobile.
EXD7090 General information 1 Precautions 1 Installation instructions 5 Making the electrical connections 5 Installing the main unit 9 After installation and connections 10 Operation instructions 11 Detaching the front panel 11 Resetting the unit 11 Control elements 12 Main unit 12 Remote 15 Main Access Menu 17 Touch Screen 17 AM/FM Tuner Operation 20 DVD Operation 22 CD Operation 24 MP3 Operation 26 iPod Operation 27 SD Card Operation 30 JPEG Operation 31 Bluetoot
General information Specifications Caution 50 51 Features Thank you purchasing this EXONIC Multimedia Disc Player. Please read this information carefully and follow all the instructions outlined below. This will ensure reliable operation and durability of your unit. Keep the packaging and operating instructions in a safe place in order to pass them on to a subsequent owner in the event of selling the unit at a later date.
Preventing accidents The video pictures appear only after you park the car and set the parking brake. When the car starts moving, the video pictures automatically disappear for safety reasons, after displaying the following caution. Do not watch the monitor while driving. You may cause a traffic accident if your attention is distracted by When installing, be sure not to damage any car parts such as pipes, tubes, fuel tank or wiring by using a drill. It can cause a fire or an accident.
I nstallation instructions DVD Region Management IMPORTANT INFORMATION Some DVD discs can be played only in certain playback modes according to the intentions of the software. Unit is designed for negative ground 12V DC systems only. The unit cannot be used in trucks or other cars As the EXD 7090 plays discs according to their intentions, some functions may not work as intended. with 24V systems.Otherwise, there is a risk of fire and damage.
Expanded Wiring Diagram -Inputs/Outputs REARVIEW CAMERA
Note: Wiring Diagram - Optional A/V Connections The remote control uses one 3 volt Lithium CR2025 battery. For best performance, replace only with CR2025 or equivalent. Installing the main unit After all connections are made, install the main unit to the dashboard. Before installation This unit is designed to be completely safe, but if not installed correctly, it can cause accidents. Be sure to verify the following points before installation.
Operation instructions TYPICAL FRONT-LOAD DIN MOUNTING METHOD Detaching the front panel You can detach the front panel of this unit. 1. Press POWER The unit is turned off. 2. Press RELEASE POWER RELEAASE Notes:Do not drop the front panel or put excessive pressure on them. Do not subject the front panel to heat/high temperature or moisture. Avoid leaving it in a parked car or on a dashboard/rear tray.
Control elements 4. Disp Press the DISP button to display CLOCK information on the secondary LCD screen when the monitor is Main unit Monitor closed closed. 1 2 4 3 5. Open/Close Monitor 5 Press OPEN to open or close the monitor. The unit will emit 1 confirmation beep upon opening, 3 beeps when closing. Be careful not to not touch or obstruct the monitor movement during the open/close sequence, or permanent damage could occur.
Monitor Open After detaching the front panel Reset button Remote 10 9 8 7 Disc-In Indicator Blue = No disc Red = Disc inserted Monitor Angle Press ANGLE to increase the monitor view angle. Press ANGLE to decrease the monitor view angle. Notes:Do not attempt to move the monitor up/down by hand - severe damage will occur. Use the front panel buttons or the remote control only. The color of the LCD monitor varies between viewing angles.
Main Access Menu There are three methods to access the MAIN menu Press the ENTER button on the right ROTARY knob. Press the MENU button on the IR Remote control. Touch the A area (upper left hand side) on the touch screen. 1 2 3 4 8 5 7 6 Touch Access Buttons ①Touch to access AM/FM TUNER mode. ②Touch to access CD/DVD mode, CD/DVD must be inserted. ③Touch to access SD card MODE, SD card must be inserted. ④Touch to access iPOD mode, iPod must be connected to activate.
AREA FDVD Search AREA C Selects PREVIOUS Track DVD Transport Control OSD Hidden Touch Screen area while in DVD mode "A-F" areas can be used in DVD mode to access: A - MAIN menu access B - Displays DVD track information C - Selects PREVIOUS chapter D - Select NEXT chapter E - Displays the full DVD transport controls F - GOTO search menu Touch Screen Controls Using the Hidden Touch Screen Controls Notes: ①Touch the A DVD disc must be inserted to access these functions and features.
Searching a DVD 13 AS/PS (AUTO STORE / PRESET SCAN) Touch the search button in AREA F. 14 BAND selection, FM1, FM2, FM3, AM Searching by Time, Title or Chapter 15 VOLUME indicator 1 . Touch the in the TIME area. 2 . A touch keypad will now appear, enter your desired TIME to search. 16 LOUD indicator 3 . Enter OK.