Trim II Pro Doorbell Camera HD video. Two-Way Audio. TRIM2 S TRIM2 B TRIM II PRO Doorbell Camera On-demand video View your front door at anytime Record video Save videos to your Alarm.
Sleek design Install on thin door trims and frames Requirements Power: 10-30VAC, 50/60Hz,0.5A Max or12VDC,0.5 to1.0A wired to inhome mechanical chime - digital doorbell chime compatibility requires SkyBell Digital Doorbell Adapter - not included Wi-Fi: 802.11 b/g/n/ac, 2.4 and 5 GHz Upload bandwidth: 2 Mbps required Mounting: Mounting plate affixes to flat surface and utilizes existing doorbell wiring Mobile device: Alarm.
Answer your door from anywhere. With the Alarm.com mobile app you get activity alerts and recorded clips so you can see whofs at your door, day and night. The built-in Two-Way Audio lets you hear and speak to visitors. When paired with other Alarm.com smart home products, you can even unlock the door or turn on lights for visitors - all right from the app. Need help? Go to alarm.com/doorbell Use Alarm.com Doorbell Camera Hardware Alarm.com’s Doorbell Camera hardware must be used: • Alarm.
Attach the Doorbell Mounting Bracket to the Wall Feed the existing doorbell wires through the hole in the center of the bracket. Affix the bracket firmly to the wall by driving the provided wall screws through the top and bottom holes in the bracket. Failure to make the bracket flush on the wall could cause a poor power connection between the bracket and the doorbell camera. Connect Power Wires to the Mounting Bracket Loosen the terminal screws and insert the wires beneath the screws.
Wi-Fi Connectivity If the LED is flashing Orange, the doorbell needs to be manually placed into AP mode. Press and hold the Main Button until the LED begins rapidly flashing green, then release. The LED will flash green as the Doorbell Camera scans the Wi-Fi networks in the area. The Doorbell Camera should enter AP Mode after a couple of minutes and the LED should begin alternating Red and Green.
Notes: The Alarm.com T r i m I I P r o Doorbell Camera will flash Blue before it flashes Yellow – do not release during the flashing Blue phase (this will power cycle the device). You can factory reset the device when it is in AP Mode (see instructions above). Press and HOLD the Main Button until the LED flashes Yellow. If a factory reset is performed on a camera that is already connected to Wi-Fi, the camera will need to be re-installed to re-establish its Wi-Fi connection.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver.
To maintain compliance with the RF exposure guidelines, place the product at least 20cm from nearby persons. Pour rester en conformité avec les consignes d'exposition aux RF, placez le produit à au moins 20 cm des personnes proches.