Operating Manual

Operating Manual

1. Press the power off button, the UVC lamp will be off in standby state and the indicator

light will always be on.

2. Press the power button, and the UVC lamp indicator light will flash slowly for 60

seconds. After 60 seconds, the UVC lamp will work.

3. Press the timing button "15min,30min,60min". After the indicator light flashes slowly for

60 seconds, the UVC lamp will start and start the timing.

"off" switch

power button

Timing of key:

30 minutes

Timing of key:

minutes

Timing of key:

minutes

PAGE 1
Operating Manual 1. Press the power off button, the UVC lamp will be off in standby state and the indicator light will always be on. 2. Press the power button, and the UVC lamp indicator light will flash slowly for 60 seconds. After 60 seconds, the UVC lamp will work. 3. Press the timing button "15min,30min,60min". After the indicator light flashes slowly for 60 seconds, the UVC lamp will start and start the timing.
PAGE 2
FCC Warning: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.