Contents 1 Safety Precautions................................................................. 2 2 Overview ................................................................................ 4 3 Charging ................................................................................ 5 4 Power on / Power off ............................................................. 6 5 Changing OSD Language & System Time ......................... 6 6 Connecting to Wi-Fi ....................................................
The phone pictures, as well as data on the phone appearance, color and design features found in the manual are for reference only. We reserve the right to change the appearance and technical parameters of the product without prior notice. 1 Safety Precautions Never attempt to disassemble your phone. You alone are responsible for how you use your phone and any consequences of its use. As a general rule, always switch off your phone wherever the use of a phone is prohibited.
as chemical plants, fuel depots and at any location where blasting operations are under way. Electronic equipment: To avoid the risk of demagnetization, do not let electronic devices close to your phone for a long time. Electronic medical equipment: Your phone is a radio transmitter which may interfere with electronic medical equipment or implants, such as hearing aids, pacemakers, insulin pumps, etc. It is recommended that a minimum separation of 15 cm be maintained between the phone and an implant.
2 Overview Front and Side panels 1 Volume +/- Button 2 Power Button 3 Microphone 4 Micro USB Port 5 Light Sensor Hole 6 Signal Lamp 7 Flash Light 4
8 Earpiece 9 Front Camera 10 Menu Button 11 Home Button 12 Back Button 13 Headphone Jack Back Panel 14 Back Camera 15 Flash Light 16 Speaker 3 Charging New batteries are shipped partially charged. Before you start using your device, it is recommended that you install and charge the battery. Some batteries perform best after several full charge/discharge cycles.
Plug the DC end of adapter to the micro USB port of the device and plug the AC end to the wall socket for charging. Normally it takes approximately 3~5 hours to fully charge the device. Operating the device during charging with the AC adapter may extend the time of full charging. 4 Power on / Power off 1) To turn on the device, press and hold the Power button until you see the start-up screen then release, it will automatically enter the Home screen.
Select Settings---Language & input---Language to change OSD language. Select Settings---Date & time to change system time. 6 Connecting to Wi-Fi On the Home menu tap on the icon and select Settings icon to access the list of options. Select Wireless & Networks. If the Wi-Fi is off, tap on the Wi-Fi line to turn it on. The device will scan for available Wi-Fi networks and display them on the screen. Tap on the network you want to connect to.
2) open the file you want to share, and choose the option “HotKnot Share”. 3) Stick the two phones’ screen together to transfer data, when the transfer begins and finishes, there will be notification beep tone. 8 Screen Casting Settings->Display->Cast Screen 1) upper right option-> enable wireless display 2) turn on “Discoverable by others”, then other devices could find and connect your phone.
10 Smart cover Settings->Smart Cover Turn it on when the phone is with a protective cover, then the screen will be locked when you close the cover. Turn on “Answer Automatically” , when there is a incoming call, your phone will pick it up automatically when you open the cover. 11 Gesture Feature In the state of the locked screen, smart gestures enable to quickly activate an application or unlock the phone by writing characters on screen.
12 Troubleshooting Q1: What if water enters the device? A: 1) DO NOT turn on the device. 2) Disconnect the outlet cable in order to turn it off instead of pressing the power button. Disconnect all external devices and then send to the service center for advice. Q2: How to check the device if it won’t turn on? A: If the power is low, connect the adapter to charge. Remove the micro-SD card and any other external device.
Q6: Why are the Bluetooth and 3G function disabled? (Applicable only for model with Bluetooth and 3G function) A:Check if the “Airplane mode” is enabled, if it is then the Bluetooth and 3G function can’t be activated. 13 Technical Specifications Processor MT6735 RAM (#) 2GB Storage capacity(#) EMMC 16GB Size LPDDRII 5.0’’ HD LCD Capacitive Multi-touch Resolution 1280×720 pixels Camera Front: 13M pixel; Back: 16M pixel Communications Operating Temperature Wi-Fi (802.11 b/g/n), Bluetooth (BT4.
Weight About 132.2g Dimension 143.2×71×8.3mm Notice The # symbol means that the item is optional. FCC WARNING Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with part 15 of the FCC Rules.
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. —Consult the dealer or an experienced radio/TV technician for help.
Specific Absorption Rate (SAR) information SAR tests are conducted using standard operating positions accepted by the FCC with the phone transmitting at its highest certified power level in all tested frequency bands, although the SAR is determined at the highest certified power level, the actual SAR level of the phone while operating can be well below the maximum value, in general, the closer you are to a wireless base station antenna, the lower the power output.
For body worn operation, this model phone has been tested and meets the FCC RF exposure guidelines when used with an accessory designated for this product or when used with an accessory that Contains no metal and that positions the handset a minimum of 1.0 cm from the body. Non-compliance with the above restrictions may result in violation of RF exposure guidelines.