User's Manual

SPW02

User Manual

1. Introduction

Beatz is a heart rate band that provides live, accurate heart rate to your mobile training app,

turning it into a smart training companion. It is compatible with dozens of fitness apps and

devices.

2. Key Features

y Uses Bluetooth to provide heart rate to your Android or IOS device.

y Compatible with iPhone 4S or above, iPod touch 5

generation, iPad 3

or 4

generation, ipad mini, ipod nano 7

generation, Android 4.3 or latest.

y Compatible with popular Fitness Apps and devices, including the compatible gym

equipments.

y Rechargeable Lithium battery with 10 hours of continuous usage per charge.

y Waterproof up to 10m.

y Ultra slim and light-weighted.

3. Functional Parts

1 Power Key Press and hold to turn on/off the Beatz

2 Battery Charging Port

Match with the charging Plug for charging up the

Beatz

3 Charging Plug Attach to the battery recharge port by magnet

4. Getting Started

4.1. Charging up Beatz

1. Take out the included USB charging cable.

2. Attach the charging Plug to the battery charging port by magnet.

The red LED will light up to indicate the Beatz is charging and it will turn off once the Beatz

has been fully charged. It takes about 2 hours to fully charge the heart rate band.

Remark:

When Beatz runs out of battery, it may take about 1 min to start charging.

4.2. Getting Started

y Fasten Beatz on your wrist snugly. Make sure the optical sensor at the bottom cover

and your skin are in good contact.

y Press and hold the Power key for 2 seconds to activate Beatz, then the blue LED will

be turned on steady.

y Beatz will start searching your heart rate immediately. Once Beatz found your heart

rate, the LED will flash slowly.

4.3. Tips to have accurate heart rate reading

In order to accurately monitor your heart rate:

1. Beatz should be worn on the back of your wrist, rather than wrist bones.

2. If you often have cold hands or not well of circulation, you can try to have a warm up

exercise for a few minutes before you begin to use Beatz to track your heart rate.

PAGE 1
SPW02 User Manual 1 Power Key 2 Battery Charging Port 3 Charging Plug Press and hold to turn on/off the Beatz Match with the charging Plug for charging up the Beatz Attach to the battery recharge port by magnet 4. Getting Started 4.1. Charging up Beatz 1. 2. Take out the included USB charging cable. Attach the charging Plug to the battery charging port by magnet. 1.
PAGE 2
3. 4. Hold your arm still until the LED begin to flash slowly, this means Beatz found your heart rate. The time to find the heart rate will be affected by a lot of factors, usually Beatz can find the heart rate within 30 seconds. You can wear Beatz higher on your forearm for biking or if you have smaller wrist. 4.4. Connecting your Beatz to App via Bluetooth 1. 2. 3. Turn on Beatz, the bluetooth will turn on automatically. Go to the Bluetooth setting of your smart device to enable the Bluetooth.