User's Manual

Motor + Argo MPC03G
User Manual
1. Key Features
 125
o
Wide Angle Lens.
 Event Video Recording for prior and after for sudden external
impact.
 Continuous loop of scenery capture for unexpected incidents.
 Geo-information capture in photo or video files with the built-in
GPS sensor.
 High quality video recording up to 1296p high quality videos.
 Photo capture during recording.
 Voice Prompt.
 Wi-Fi Function.
2. Functional Parts
1 Micro USB Port
Connect to PC for file browsing
and file transfer
2 DC in Port
Connect to the provided DC in
to USB cable for charging
3
microSD Slot
microSD card storage location
4
Wide Angle Lens
Capture a wide angle view
5
Reset Button
Reset the Argo
6
Speaker Vent
Output the sound
7 Mounting Socket
Install the windshield mount. You
can detach the socket on the top
of the Argo to mount the Argo on
the other optional mounting
accessories
8
Wi-Fi LED
Indicator
Wi-Fi status indication
9
Status LED
Indicator
Operation status indication
10
GPS LED Indicator
GPS status indication
11
Capture a photo during recording
12
Manually trigger an Event
Protection Video Recording
13
Wi-Fi Button
Turn on/off Wi-Fi function
3. Installing the Windshield Mount &
Argo in a Vehicle
1. Clean the area on the windshield.
2. Peel off the protective membrane of the 3M adhesive and stick
the Windshield Mount to the front windshield inside the car.
3. Slip the socket on the top of the Argo into Windshield Mount
until it is latched.
4. The lens of Argo should be at the center of the front windshield
and be aware not to block the driver’s visibility.
5. Adjust the nut on the Winds hield Mount for suitable direction
and orientation.
6. Connect the Argo to the DC Power jack with included DC in to
USB cable and the Dual USB CLA. Secure the cable with the
cable holder to avoid from interference of driver's motion.
7. Press the Windshield Mount side to release and slide the Argo
off the mount.
4. LED Indication
“RED” Status LED
ON
Argo is under Normal Looping
Recording.
“RED” Status LED
Flashes continuously
Counting down and the Argo is going to
turn off due to the power source is
removed.
“PURPLE” Status
LED ON
Argo is under Event Protection
Recording.
“BLUE“ Status LED
ON
Argo is connecting to PC through USB
cable.
Blue & Red status
LED alternating flash
1. No memory card is installed
2. Memory card is less than 8GB
3. Card error
“ORANGE” GPS LED
ON
GPS signal is received.
“ORANGE” GPS LED
Flashes
No GPS signal or GPS signal is weak.
“GREEN” Wi-Fi LED
ON
Wi-Fi is initializing.
“GREEN” Wi-Fi LED
Flashes slowly
Wi-Fi is ready for connection or
enabled.
“GREEN” Wi-Fi LED
Flashes rapidly
Data is transferring in Wi-Fi mode.
5. Using Your Argo
5.1. Inserting a microSD Memory Card (not
included)
Insert a microSD card (not included) to the slot before using the Argo.
Assure that the Argo power is turned OFF before inserting the card.
A min 8GB, Class 6 or above card is recommended.