User Manual Design To turn on the device, keep the ON button pressed for a couple of seconds. 1 Earphone Jack 6 Microphone- 2 USB port 7 Volume +/- 3 Proximity Sensor 8 Power key 4 Receiver 9 Rear camera 5 Front camera 10 Speaker How to install SIM card and battery Follow the steps shown on the image located in the back part. Please note that the device has 2 slots for SIM cards. Make sure that the back cover is well placed and closed after you insert the SIM card(s).
1. Press RESET button 2. Press ON button for a couple of seconds 3. Take out the battery Charge the battery Before using the device for the first time or if the battery has not been used for a long time, you need to charge the battery. Use only approved chargers, batteries and cables. Unapproved chargers or batteries can damage the battery or the device. Connect the small end part of the charger to the device’s multifunction slot and the big end part of the charger to an electric source.
Do not bend or damage the power cord. Doing so could cause electric shock or fire. Do not touch the power cord with wet hands or pull the cord to disconnect the charger. Doing so could cause an electric shock. Do not short-circuit the charger or the device. Doing so could cause electric shock or fire, or the battery may malfunction or explode. Do not use the device outdoors during a thunderstorm. Doing so could cause electric shock, or the device may malfunction.
Comply with all safety warnings and regulations regarding the use of mobile devices while driving Correct use and maintenance Keep the device dry Do not store the device in hot or cold areas.
Do not use the device if the screen is cracked or broken Install mobile devices and equipment with caution Do not let the product drop or subject to strong impact Ensure maximum duration for battery and charger Avoid charging the device for more than a week, as overcharging may shorten the battery life. Over the time, if the device is not used, it will be discharged and needs to be recharged to use it Unplug the charger from the power supply when not in use.
Household users should contact either the retailer where they purchased this product or their local authorities to find out how and where they can take to be subjected to environmentally safe recycling. Business users should contact their supplier and check the conditions of the purchase contract. This product and its electronic accessories should not be mixed with other commercial waste.
Treatment for common problems 1. Data erase To erase information and reset factory data, please follow these steps: settings – security copy – reset factory data – accept. 2. No voice in the earphone Make sure the volume is not turned down all the way Unplug the headset. Plug it in again. Make sure you push connector all the way in. 3. Charging issues Please make sure the setting of the charger is according with the device.
FCC Statement 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
granted an Equipment Authorization for this model phone with all reported SAR levels evaluated as in compliance with the FCC RFexposure guidelines. SAR information on this model phone is on file with the FCC and can be found under the Display Grant section of http://www.fcc.gov/ oet/fccid after searching on FCC ID: 2ABOSSKYELITEB55 Additional information on Specific Absorption Rates (SAR) can be found on the Cellular Telecommunications Industry Asso-ciation (CTIA) web-site at http://www.wow-com.com.