User's Manual

TRANSMITTER

MODEL: SD-T2DP-C

USER MANUAL

一、 SPECIFICATION

1. Model：SD-T2DP-C

2. Frequency：27.145MHz

3. Battery：9.0V 6× AA alkaline batteries

二、 OPERATION DIRECTION

1. Open the battery cover on the bottom of transmitter, install six AA alkaline

batteries according to the directive, ensure batteries are installed correctly and

then close the battery cover.

2. Pull the antenna completely, turn on the power switch on the left of transmitter,

the directive light will be on. If the directive light is off, please check the

installation of batteries, and power switch is “ON” or “OFF”.

3. CH1 channel control the rotate speed value of the two motors in the left and

right. Move the joy stick to the right, the rotate speed of right motor is

exceeded left motor. Move joy stick to the left, the rotate speed of left motor is

exceeded right motor. Loosen joy stick, let it move to the original position, the

rotate speed of the two motors will be kept consistently.

4. CH2 channel control speedup and speed-down of the two motors at the same

time. Press the button, two motors will be speedup; Loosen the button, two

motors will be speed-down at the same time.

三、 CAUTION

1. It must be pulled the antenna completely when use transmitter. Prohibit to turn

on the power after drawing back the antenna for fear damage the electric

circuit.

2. When the red light is on and green light is flickered, it shows battery capacity

is not enough, please replace battery as soon as possible for avoiding to effect

PAGE 1
TRANSMITTER MODEL: SD-T2DP-C USER MANUAL 一、 SPECIFICATION 1. Model：SD-T2DP-C 2. Frequency：27.145MHz 3. Battery：9.0V 6× AA alkaline batteries 二、 OPERATION DIRECTION 1. Open the battery cover on the bottom of transmitter, install six AA alkaline batteries according to the directive, ensure batteries are installed correctly and then close the battery cover. 2. Pull the antenna completely, turn on the power switch on the left of transmitter, the directive light will be on.
PAGE 2
the operation of transmitter. 3. To avoid interference each other, please don’t operate the transmitter near the other object which with same frequency. FCC Statement: “Modifications not authorized by the manufacturer may void users authority to operate this device.” NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.