WLAN+BLE Module MODEL NO:1DX Quick Installation Guide
I. Installation steps WLAN 1. First, install Murara Wireless+BLE combo Driver of EVM Board. 2. Make "RCT" folder in a root directory of the micro SD card. 3. Make "WlanTest.txt" file in the RCT folder. (WLAN continuous transmission/receiving mode) 4. Insert MICRO SD CARD into EVM Board 5. Click the Power key, wait for 5 seconds entry test mode. BLE 1. First, install Murara Wireless+BLE combo Driver of EVM Board. 2. Make "RCT" folder in a root directory of the micro SD card. 3. Make " BTTest.
II. DC/RF Characteristics Supply Voltage Storage Temperature Supply Voltage -40~+85 degree C VBA DC 3.3V from host VDDIO DC 3.3V from host DC/RF Characteristics for IEEE802.11 b/g/n Specification IEEE 802.11b, IEEE 802.11g, DSSS/CCK:up to, 11Mbps Data rate Output Power IEEE 802.11n, OFDM:up to 54Mbps OFDM:up to 65Mbps Max 19 dBm Max 23 dBm Operating Channel Max 23 dBm CH1~CH11 DC/RF Characteristics for Bluetooth(LE) items Contents Bluetooth specification (power class) Version 4.
Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
This device is intended only for OEM integrators under the following conditions: 1) The transmitter module may not be co-located with any other transmitter or antenna. As long as 1 conditions above are met, further transmitter test will not be required.
Industry Canada statement: This device complies with ISED’s licence-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Le présent appareil est conforme aux CNR d’ ISED applicables aux appareils radio exempts de licence.
co-location with another transmitter), then the Canada authorization is no longer considered valid and the IC ID can not be used on the final product. In these circumstances, the OEM integrator will be responsible for re-evaluating the end product (including the transmitter) and obtaining a separate Canada authorization.
prohibited for use with this device. Le présent émetteur radio (IC: 11195A- 1DX / Model: 1DX) a été approuvé par ISED pour fonctionner avec les types d'antenne énumérés ci-dessous et ayant un gain admissible maximal. Les types d'antenne non inclus dans cette liste, et dont le gain est supérieur au gain maximal indiqué, sont strictement interdits pour l'exploitation de l'émetteur. Approved antenna(s) list Type Gain Brand Manufacturer Monopole 2.