Specifications

ManualsBrandsSinope Technologies ManualsElectronicsZigbee Module

Sinope technologies, 705 Montrichard, St-Jean-Sur-Richelieu, Qc, Canada, J2X5K8

T :450-741-7700

ZBM1502

802.15.4/Zigbee Radio Module

2019-10-17

Product Features

 FCC and ISES Approvals

 802.15.4 Compliant

 Integrated amplifier : 19.5dB

 RF data rate : 250kbps

 Frequency band : 2.4Ghz

 Network topology support : Mesh, Point to point

 Antenna type : PCD IFA strip

 Internal voltage regulator to limit TX power fluctuation

Operating conditions

Parameter

Min

Typical

Max

Value

Supply Voltage

2.9

3.8

Vdc

Operating temperature

40°

60°

°C

Electrical Specifications

Parameter

Min

Typical

Max

Value

RX supply current

140

Transceiver Specifications

Parameter

Min

Typical

Max

Value

Modulation

QPSK

DSSS

TX power

19.5

dBm

RX sensitivity

112

dBm

Supply voltage

Although the transceiver does not have a voltage regulator to guaranty the power of the

transmission output, It is not recommended to use a supply voltage higher than 3.8V. Higher

supply voltage might damage the module.

Summary of content (3 pages)

PAGE 1
ZBM1502 802.15.4/Zigbee Radio Module 2019-10-17 Product Features         FCC and ISES Approvals 802.15.4 Compliant Integrated amplifier : 19.5dB RF data rate : 250kbps Frequency band : 2.4Ghz Network topology support : Mesh, Point to point Antenna type : PCD IFA strip Internal voltage regulator to limit TX power fluctuation Operating conditions Parameter Supply Voltage Operating temperature Min 2.9 -40° Typical Max 3.
PAGE 2
TX power settings The maximum power setting can be used for all 802.15.4 channels,. Dimensions: Compliance Statements: FCC Compliance Statement (Part 15.19) This transmitter module meets the FCC Rule Part 15C requirements. Operation is subject to the following two conditions: 1) This device may not cause harmful interference. 2) This device must accept any interference received, including interference that may cause undesired operation. FCC Interference Statement (Part 15.
PAGE 3
installed must also display a label referring to the enclosed module. This exterior label can use wording such as the following: “Contains Transmitter Module FCC ID: 2AK2T-ZBM1502” or “Contains FCC ID: 2AK2T-ZBM1502” Warning (Part 15.21) Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.