Model PG-20 Manual Grommet Machine Operating Manual (800) 624-2408 (530) 626-9386 Fax (530) 626-5144 6686 Merchandise Way Diamond Springs, Ca 95619 www.sineqco.
INTRODUCTION MANUAL MACHINE MODEL PG-20 FOR PLACING APPLICATIONS BY HAND The function of this machine is the placement of applications or to punch holes (interior diameter of tube grommet 8mm or 12mm) in materials that need these applications. Specially recommended for placing grommets and washers in: awnings, curtains, advertising signs, etc. THIS MACHINE WILL PUNCH THE MATERIAL WHILE SIMULTANEOUSLY SETTING THE GROMMET.
Installation of PG-20 Install grommet machine on secure table top with the front of machine base flush with table edge. Use four bolts with lock nuts/washers to secure machine. Adjusting both the cutting and the grommet pressure. ALWAYS ADJUST FIRST THE CUTTING PRESSURE, NEVER TRY DO CUTTING AND SETTING AT THE SAME TIME. Each time you change material or change grommet sizes, it will be necessary to adjust the pressure for the machine to work properly.
In order to adjust the grommet pressure. - - Insert grommet on die #3 as shown in figure 1 below. Make sure bottom of grommet is up above bottom of top die. No washer is needed for 8mm grommets. For 12mm grommets, insert washer on die #4 as shown in figure 2. Do a test grommet with the material you are using, Slowly loosen #2 die to tighten grommet fit. Use ΒΌ turns or less at a time. Try to spin grommet in material.
Change Of Dies The PG-20 will take two die sets. If you want to change out sizes, you will need to replace parts. Please refer to the following diagrams. 8mm Die Set 12mm Die Set Only used in 12mm die set.
Parts Schematic
Schematic # Part # Description 30 31 32 33 34 36 37 38 39 40 41 42 43 44 45 46 48 49 50 51 52 58 PGR2030 PGR2031 PGR2032 PGR2033 PGR2034 PGR2036 PGR2037 PGR2038 PGR2039 PGR2040 PGR2041 PGR2042 PGR2043 PGR2044 PGR2045 PGR2046 PGR2048 PGR2049 PGR2050 PGR2051 PGR2052 PGR2058 Machine Head Die Holder Pin Driving Stem Driving Stem Guide Wheel Pin Driving Stem Guide Wheel Eccentric Part Connecting Rod Connecting Rod Pin Adjusting Nut For Top Die Screw For Fixing Lever Lever Pin Draw Back Spring Driving Stem C
NOTES