SIMA 3X1 HDMI SWITCHER Model VS-HD31 Please register online at www.simaproducts.
Caution: IMPORTANT SAFEGUARDS FOR AUDIO PRODUCTS. PLEASE READ CAREFULLY THE FOLLOWING IMPORTANT SAFEGUARDS THAT ARE APPLICABLE TO YOUR EQUIPMENT 1. Read instructions - All the safety and operating instructions should be read before the appliance is operated. 2. Retain instructions - The safety and operating instructions should be retained for future reference. 3. Heed Warnings - All warnings on the appliance and in the operating instructions should be adhered to. 4.
INTRODUCTION Congratulations on your purchase of the 3x1 HDMI Switcher. Sima Products HDTV switches are designed to make your A/V equipment use more efficient, more creative and most affordable. The 3x1 HDMI Switcher allows access to three HDTV devices, using one HDTV display. The 3x1 HDMI Switcher allows three HDTV HDMI devices to be switched easily in to one HDTV HDMI compatible monitor or projector. Simply connect your HDTV display to the Switcher’s display output.
PANEL DESCRIPTIONS Front Panel 1. IR Eye 2. Indicator LED Input 1 3. Indicator LED Input 2 4. Indicator LED Input 3 5. Input Selector 6. Signal Enhancement LED 7. Signal Enhancement Selector 8. Power Indicator LED SIMA 3x1 1 2 3 4 5 6 7 8 Back Panel Output Input 3 Input 2 Input 1 Power Connector Remote Control Power button to toggle device on/off 9 digit keypad (1 –2 –3 will be used to toggle between the inputs) • Buttons 4 through 9 are not available with this device.
Installation: 1. Choose the correct connector for the country in which you are located. U.S. Prong Tip 2. Install the adapter tip on the adapter body by placing the top of tip into slot and snapping bottom of tip into place. (as shown below). U.K. Prong Tip EU Prong Tip AUS Prong Tip 3. To change tips, slide down spring loaded trigger, pulling up on adapter tip. How to Connect the 3x1 HDMI Switcher to your devices 1. Plug the 5VDC power supply into the 3x1 HDMI switcher and correct AC wall outlet. 2.
How to Control the 3x1 HDMI Switcher 1. There is no power switch on the device itself. Power is automatically turned on when plugged into a wall outlet. 2. Press the Input button on the front panel to toggle among the 3 inputs. Or use the IR remote control to directly set an input. 3. Press the signal enhancement button on the front panel to turn on this feature. When activated, the LED will illuminate. This will improve the signal quality when long distance installations are required.