Overview Self-adjusting headset Microphone Volume +/Vibration on/off Microphone on/off Scope of supply MHS5100USB headset Stand Drivers CD Instruction Manual
Important notes Before using the appliance for the first time, please carefully read through the following instructions and note all warnings, even if you are familiar with handling electronic equipment. Store this manual in a safe place for future reference. If you sell or give away the appliance, please ensure you handover this manual too. OPERATING ENVIRONMENT - - The appliance is not designed for use in rooms with a high temperature or air humidity (e.g. bathrooms) or excessive dust.
Important notes CE DECLARATION OF CONFORMITY This appliance has been tested and approved with respect to compliance with the basic requirements and other relevant regulations of the EMC Directive 89/336/EEC, the Directive for low voltage electrical equipment 73/23/EEC and the R&TTE Directive 99/5/EC. NOISE POLLUTION Never operate the headset at a high volume. You put your hearing at risk and can also disturb your environment. Please do not use the headset in dangerous situations, e.g.
Installation Connect the headset's connector with one of the USB connections of your computer. Ensure the connector is correctly inserted. Your computer's operating system now installs the headset's drivers.
Installation Now, please insert the driver and software CD in your CD/DVD drive. The CD starts automatically. If the installation window does not appear automatically, please right-click your CD/DVD drive in "My Computer" and select "Open". Then click "Setup.exe" to start the installation. Please click "Next" to start the installation. In the following window you can select whether you want to install the drive only or the driver and demo software, and then click "Next".
Settings After your computer has restarted you will find a new symbol in the taskbar: You can use this symbol to start the "USB 3D Sound Configuration" software of your headset. Under "Main settings" (see following screenshot) you will find the settings for choosing the output device. You can enable DSP mode for the output device and enter the settings, e.g. volume control for all channels, "virtual" rotating of the loudspeakers and reset to the default settings.
Settings In the "Mixer" you can configure the volume for diverse input and output options (see following screenshot). Or you can activate the microphone amplifier (MIC boost) or switch the microphone to mute.
Settings Under "Effect" (see following screenshot) you can enter manual settings for the equalizer or select one of the preset equalizer configurations. You can also select an environment/room atmosphere.
Settings Here (see following screenshot) you can enter settings for karaoke. To enter settings, click the "On" button. Please confirm the following message window concerning selection of the microphone settings by clicking "Ok". If you now set ticks in front of the respective options you can enter your settings there.
Notes ___________________________________________________________________________ ___________________________________________________________________________ ___________________________________________________________________________ ___________________________________________________________________________ ___________________________________________________________________________ ___________________________________________________________________________ __________________________________________________