I-210+ and I-210+c NIC Labeling Integrator's Guide Silver Spring Networks SSN - I-210+ NIC FCC Labeling 070614.
I-210+ and I-210+c NIC Labeling Integrator's Guide 1 Introduction The Silver Spring Networks I-210+ Network Interface Card (NIC) is a FCC Part 15.247 compliant device that enables communication between Silver Spring Networks AMI network and the I-210+ and I-210+c family of meters. The NIC transmits in the 902 to 928 MHz, ISM band and transfers data from utility meter to Silver Spring Networks Relays and Gateways.
I-210+ and I-210+c NIC Labeling Integrator's Guide Figure 3 – Label Locations on Top Side of I-210+ NIC PCA NIC Address Label FCC & GE Part Number Label Figure 4 – Bottom Side of I-210+ NIC PCA SSN Corporate Name SSN Model Number 3 FCC and Government Guidelines Silver Spring Networks NIC FCC ID: OWS-NIC501 IC: 5975A-NIC501 The I-210+ NIC is REQUIRED to be professionally installed within the host meter by a properly trained technician.
I-210+ and I-210+c NIC Labeling Integrator's Guide Figure 5 – Sample Label for NIC PCBA FCC ID: OWS-NIC501 IC: 5975A-NIC501 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
I-210+ and I-210+c NIC Labeling Integrator's Guide wording that expresses the same meaning may be used. The Grantee may either provide such a label, an example of which must be included in the application for equipment authorization, or, must provide adequate instructions along with the module which explain this requirement. In the latter case, a copy of these instructions must be included in the application for equipment authorization.