User's Manual

ManualsBrandsSilver Spring Networks ManualsElectronicsUtility Meter WLAN Module

Silver Spring Networks Proprietary Information

Silver Spring Networks NICv4.1

Preliminary Product Details Guide

1 Introduction

This guide explains how to install and configure the NIC is a radio device that enables

communication between Silver Spring Networks automated metering infrastructure. It transmits

in the 920 to 928 MHz band and typically transfers data from utility meters to Silver Spring

Networks Relays and Gateways.

1.1 Regulatory

Silver Spring Networks

NIC

FCC ID OWS-NIC41

IC: 5975A- NIC41

The device complies with Part 15 of the FCC rules. Operation is subject to the following two

conditions:

1. The device may not cause harmful interference, and

2. The device must accept any interference received, including interference that may cause

undesired operation.

For Canada:

To reduce potential radio interference to other users, the antenna type and its gain should be

so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that

permitted for successful communication.

Disseminating end-user documentation for the installation/removal of the NICv4.1 is

expressly prohibited by regulatory statues.

Figure 1 is a sample of the FCC ID label that can be found in the location indicated in Figure 2.

The size of the label is approximately 1.75 x 3.50 inches.

Figure 1. FCC ID Sample Label

FCC ID: OWS-NIC41 IC: 5975A- NIC41

This device complies with Part 15 of the FCC Rules. Operation

is subject to the following two conditions: (1) this device may

not cause harmful interference, and (2) this device must

accept any interference received, including interference that

may cause undesired operation.

Summary of content (5 pages)

PAGE 1
Silver Spring Networks NICv4.1 Preliminary Product Details Guide 1 Introduction This guide explains how to install and configure the NIC is a radio device that enables communication between Silver Spring Networks automated metering infrastructure. It transmits in the 920 to 928 MHz band and typically transfers data from utility meters to Silver Spring Networks Relays and Gateways. 1.
PAGE 2
Figure 2. FCC IC Label Location on NIC This equipment has been tested and found to comply with Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
PAGE 3
IC RF Radiation Exposure Statement The installer of this radio equipment must ensure that the antenna is located or pointed such that it does not emit RF field in excess of Health Canada limits for the general population; consult Safety Code 6, obtainable from Health Canada’s website: www.hc-sc.gc.ca/rpb This device has been designed to operate with the antennas listed below, and having a maximum gain of 4.5 dBi.
PAGE 4
• • • • • • • • • • • Keep unauthorized people out of the work area. Be especially cautious of children, who tend to be drawn to work activity. Determining if a circuit is OFF can be difficult in some instances. Check for circuit voltage with an appropriate voltmeter before working on equipment presumed to have been deenergized. Tiebreakers, double throw disconnect switches, automatic transfer switches and emergency generators can supply power through an alternate circuit or from another source.
PAGE 5
• • • should be at the proper angle. If a ladder angle label is provided, follow its recommendations. If the ladder is to remain in place for an extended period, secure it at the top. The support point at the top of the ladder should be at least 24 inches (60 centimeters) wide to maintain support in the event of sideways movement. For jobs of short duration, have a fellow worker support the ladder at the base.