1.JuU..1999 18:13 P.3/3 F.C.C. GUIDELINES 1 WARNING: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, Uses and can radiated radio frequency energy and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
21. JUL. 1993 18:13 NO. 350 P.4-3 INTRODUCTION 2 Thank you for choosing this innovative product. This keyboard is one of the SK-2300C series products, which are 104/105/106/107/109 keys enhanced keyboards for IBM PC/AT, PS/2 and its compatibles. OPERATION 3 * Mode Selection Selection is done by auto-switchable. ; | This keyboard is designed to be AT,PS/2 ode 1 I 3.2 Mode Indicators 3.
21.JUL.1833 18:14 CABLE AND CONNECTOR 4 The keyboard shielding cable long cable, The k the host unit through a Din connector . The following figures the come cor pin and thee sign. on oars clock d data 5 Vdc Vde NO. 258 i oars cable is connected to Description Signal Pins keyboard data 5 Vdc sigma! 1 2 ground 0 3 power supply 3 Vde 4 keyboard clock S$ Vdc signal 5 6 P.
21.01.1999 18:15 TECHNICAL DATA 3 5.1 Electrical ct i. 5.2 Mechanical Characteristics 5.3 Environmental Specifications Input Power: +5 VDC,80 mA max. 1 Power Consumption: 0.4 watts max. Total Travel: Traveler: 2.5 0.
21.JUL.1998 18:14 3.4 Thematic Delay and Repeat Rate 3.5 Pseudo N-Key Roll-over Capability 3.6 Diagnostic Test With the exception of the Pause key, all keys are thematic. When a key is pressed and held down, the keyboard delays 0.3 sec. snd begins sending a make code for that key at a rate of 10.9 characters per second. (The delay is called thematic Delay and the rate is called Repeat Rate) t If two or more keys are pressed, only the last key pressed is repeated at the repeat rate.
21... 1999 18:13 NC. dod P.2s9 CONTENTS 1. EMI GUIDELINES 2. INTRODUCTION 3, OPERATION mee mn 3.1 PC/AT, P§/2 Mode Selection 3.2 Mode Indicators 3.3 Type Ahead Capability 3.4 Thematic Delay & Repeat Rate 3.5 Pseudo N-key Roll-over Capability | 3.6 Diagnostic Test ‘ 4. CABLE & CONNECTOR 5. TECHNICAL DATA 5.1 Electrical Characteristics 52 Mechanical Characteristics 5.3 Environmental Specifications 6.