INSTALLATION GUIDE Alberga Business Park, Bertel Jungin aukio 3 FI-02600 Espoo, Finland Phone: +358 9 435 5060 www.silabs.
Figure 9.4: Recommended PCB Land Pattern Qualified Antenna Types This device has been designed to operate with a standard 2.14 dBi dipole antenna. Any antenna of a different type or with a gain higher than 2.14 dBi is strictly prohibited for use with this device. Using an antenna of a different type or gain more than 2.14 dBi will require additional testing for FCC, CE and IC. The required antenna impedance is 50 Ω. Antenna type Dipole Maximum gain 2.
FCC This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by Silicon Labs could void the user’s authority to operate the equipment.
MODELS MGM12P02GE and MGM12P02GA: “Contains Transmitter Module FCC ID: QOQMGM12P0” or “Contains FCC ID: QOQMGM12P0 MODELS MGM12P22GE and MGM12P22GA: “Contains Transmitter Module FCC ID: QOQMGM12P2” or “Contains FCC ID: QOQMGM12P2 MODELS MGM12P32GE and MGM12P32GA: “Contains Transmitter Module FCC ID: QOQMGM12P3” or “Contains FCC ID: QOQMGM12P3 The OEM integrator has to be aware not to provide information to the end user regarding how to install or remove this RF module or change RF related parameters in the
The MGM12P module has been certified for integration into products only by OEM integrators under the following conditions: • • The antenna(s) must be installed such that a minimum separation distance as stated above is maintained between the radiator (antenna) and all persons at all times. The transmitter module must not be co-located or operating in conjunction with any other antenna or transmitter. As long as the two conditions above are met, further transmitter testing will not be required.
1. Ce composant ne doit pas générer d’interférences 2. Ce composant doit pouvoir est soumis à tout type de perturbation y compris celle pouvant nuire à son bon fonctionnement. Déclaration d'exposition RF L'exception tirée des limites courantes d'évaluation SAR est donnée dans le document RSS102 Issue 5. Les modules MGM12P22GA, MGM12P22GE, MGM12P02GA et GM12P02GE répondent aux exigences requises lorsque la distance minimale de séparation avec le corps humain est de 20 mm.
ou "Contient IC: 5123A-MGM12P2 MODÈLES MGM12P32GE et MGM12P32GA: "Contient le module émetteur IC: 5123A-MGM12P3" ou "Contient IC: 5123A-MGM12P3" L'intégrateur OEM doit être conscient qu’il ne doit pas fournir, dans le manuel d’utilisation, d'informations relatives à la façon d'installer ou de d’enlever ce module RF ainsi que sur la procédure à suivre pour modifier les paramètres liés à la radio.