Installation Instructions

ManualsBrandsSilicon Laboratories Finland ManualsElectronicsMGM111 802.15.4 Module

Alberga Business Park, Bertel Jungin aukio 3

FI-02600 Espoo, Finland

Phone: +358 9 435 5060

www.silabs.com

QUALIFIED ANTENNA TYPES FOR

MGM111E

MGM111E is approved with a standard 2.14 dBi dipole antenna. Any antenna of the same

type, similar in-band out of band characteristics and with the same or less gain can be used

without reassessment. In case using antenna of a different type and/or higher gain

reassessments and notification to the particular certification authority is required.

Summary of content (5 pages)

PAGE 1
QUALIFIED ANTENNA TYPES FOR MGM111E MGM111E is approved with a standard 2.14 dBi dipole antenna. Any antenna of the same type, similar in-band out of band characteristics and with the same or less gain can be used without reassessment. In case using antenna of a different type and/or higher gain reassessments and notification to the particular certification authority is required. Alberga Business Park, Bertel Jungin aukio 3 FI-02600 Espoo, Finland Phone: +358 9 435 5060 www.silabs.
PAGE 2
FCC This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by Silicon Labs could void the user’s authority to operate the equipment.
PAGE 3
“Contains FCC ID: QOQMGM111 The OEM integrator has to be aware not to provide information to the end user regarding how to install or remove this RF module or change RF related parameters in the user manual of the end product.
PAGE 4
ISEDC This radio transmitter (IC: 5123A-MGM111) has been approved by Industry Canada to operate with the embedded chip antenna and a standard 2.14 dBi dipole antenna. Other antenna types are strictly prohibited for use with this device without reassessment and permissive change. This device complies with Industry Canada’s license-exempt RSS standards.
PAGE 5
CE The Declaration of Conformity may be consulted at www.silabs.com. Please note that every application using the BGM121 or BGM123 will need to perform the radio EMC tests on the end product according to EN 301 489-17. The conduced test results can be inherited from the modules test report to the test report of the end product using BGM123 or BGM121. EN300328 radiated spurious emission test must be repeated with the end product assembly.