User Manual

ManualsBrandsSilent Call Communications ManualsElectronicsFire Alarm Transmitter

Signature Series 418 Transmitters

There are two types of transmitters used in the Signature Series. They are:

1. The Sound Detection Transmitter

Sound Monitor Transmitter SM5-SS

2. The Alarm Input Transmitter

Consolidated with Battery (Dry Contact)

Consolidated with out Battery (Voltage Input)

The Signature Series Transmitter are preset at the factory for the alert function and do not

require any additional setting. Each transmitter contains a 5 position dip switch for setting

the address.

Telephone Transmitter

Operation

1. Whenever the telephone rings, the red test light on the telephone transmitter lights

and the transmitter will cause a PHONE indication on any Signature Series Silent

Call receiver except the Shakeup.

2. Range is approximately 1500 - 2,000 feet, depending on local conditions.

3. The telephone is powered by two AA size alkaline cells which should last a year or

more depending on use.

Low Battery Indicator

Transmitter Test Indicator

Product Name: Fire Alarm Transmitter

Model No.: FA3-SS, FA4-SS

Summary of content (6 pages)

PAGE 1
Product Name: Fire Alarm Transmitter Model No.: FA3-SS, FA4-SS Low Battery Indicator Transmitter Test Indicator Signature Series 418 Transmitters There are two types of transmitters used in the Signature Series. They are: 1. The Sound Detection Transmitter Sound Monitor Transmitter SM5-SS 2.
PAGE 2
Dry Contact Style Transmitters with Batteries Weather Transmitter Carbon Monoxide CO3-SS Door Access / Window Transmitter DW3-SS Fire Transmitter FA3-SS TransMATTer MAT-SS Doorbell Transmitter w/button DB2-SS Operation 1. The Dry Contact Transmitters will transmit as long as the contact closure is made maintaining the alert output and will stop transmitting when the alert output goes back to normal or standby condition. 2. Range is approximately 1500 - 2,000 feet, depending on local conditions. 3.
PAGE 3
The Alarm Input Transmitters uses external connections for detection and transmission of the alarm signal such as, a Switch Closure, Telephone Line Ring Detection, Doorbell Chime Connection (Direct Wired Doorbell), or Fire Control Panel Connection. The Sound Monitor Transmitter uses its internal sound monitoring circuit for the detection of audible alarms such as Smoke, Fire, CO, Telephone, Baby, Doorbell or other audible alarms.
PAGE 4
Plug-in the external vibrator or telephone cables if desired. All Fire and smoke detector transmitters should be programmed first! Please refer to the instructions included with your Signature Series Sidekick receiver. Turn on the transmitter. Within a range of one or two feet from the Sidekick: On the Sidekick press the mode button. A flashing display with the letters PPP indicates that the Sidekick is ready to receive as well as the Yellow LED 3 will light.
PAGE 5
7 Not used NOTE: The switch settings are set prior to turning on the power. Any tampering with the switch settings after power has been applied will not alter the address or alarm mode of the transmitter. The transmitter is ready to detect and send an alarm once the switch settings have been made and power applied (ON/OFF switch turned ON). The Sound Monitor Transmitter will send an alarm based on two conditions: 1. The test pushbutton is pressed or 2. An audible alarm is detected.
PAGE 6
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.