User Manual

“Silent Touch” Watch Receiver Model # W08-SS
Watch Charger/Docking Station Model # WC-SS
The “Silent Touch” Watch is a body worn receiver designed to operate as a watch, wake-up alarm and a built-in
receiver that operates with any Silent Call Signature Series transmitters.
When the watch receives a transmitted signal a specific I CON for that signal will display on the face of the “Silent
Touch” Watch. The Watch will vibrate a specific code for each transmitted signal. When the “Silent Touch” Watch is
being charged in the docking station, the external vibrator will pulse the alarm code, these are the same vibration codes
you receive when wearing the “Silent Touch” Watch.
Vibrator Pulse Outputs
SOUND = three short pulses
PHONE = one long pulse
DOOR = two short pulses
WEATHER = one short and one long pulse
FIRE = continuous short pulses
C O Carbon Monoxide = three short pulses and one long pulse
When you connect the Silent Call bed vibrator (Model # VIB-PJ) to the Watch Charger Docking Station it enables
the Watch Charger to serve as an alerting system when the “Silent Touch” Watch is being charged.
Setup and Operation:
1. Your Silent Touch Watch comes from the factory mounted in the docking station. When you first receive it,
you must remove the Silent Touch Watch from the docking station by pushing down on the release button to
the left of the watch. There will be a small round label over the charging pins that must be removed before
attempting to charge the Watch Receiver. Once you have removed this label you can now follow the
instructions below to charge your Silent Touch Watch Receiver.
2. Install the “Silent Touch” Watch Receiver into the charger/docking station by f irst inserting the right side with
the s wi tc hes mark ed SW 1 & SW2 on an angle into the docking station (see Fig.1) then gently pushing down on
the left side until it snaps into place (see Fig.2)
3. Plug the power supply pin jack into the connector located to th e left of the Battery Backup ON/OFF switch on
the back of the Docking station. (see page 2 for diagram) Plug power supply into a standard 120 volt electrical
wall outlet and Slide the Battery Backup Switch to the “On” position.
4. Turn charger on by sliding the ON/OFF SWITCH on top of the Charger/Docking Station to the “ON” position.
The watch display will show the time 11:59 am . The charging indicator light, on the right side of the docking
station, will illuminate. T h e red LED (light) indicates that the AC power is on and the watch is charging. A blue
LED (light) indicates that the wat ch is f ully charged.
5. Your “Silent Touch” Watch Receiver is now ready to use.
F i g .1
Fig. 2