User Manual

1. Reset: Press to reset if HDMI extender

doesn’t work properly

2. HDMI In:

Connect with HDMI source device

3. IR OUT: Connect with IR Blaster cable

4. Power Jack: Connect with power adapter

5. Power LED:

On when the device is powered

6. RJ45: Link to the RX via a Cat5e/6 cable

7. Activity LED:

Bilnks during data transmission

8. LINK LED: On when the TX/RX connected

Features

• Supports HDMI 1.3, HDCP 1.4

• Supports 1080p@60Hz

• Extend over a Cat5e/6 cable up to 120m

• Support IR frequence 20-60kHz

Package contents

• HDMI HDbitT Extender TX & RX

• Power adapter DC 5V/1A x2

• IR Blaster cable

• IR Receiver cable

• Quick Start Guide

Layout

Transmitter

Support

For more info or tech support

http://www.siig.com/support

uly

Dear Valued Customer

(Just WANTED YOU TO KNOW)

WE REALLY

APPRECIATE

YOUR PURCHASE

PAGE 1
Features Dear Valued Customer (Just WANTED YOU TO KNOW) WE REALLY APPRECIATE YOUR PURCHASE Support For more info or tech support http://www.siig.com/support July, 2018 Copyright © 2018 by SIIG, Inc. All rights reserved. • • • • Supports HDMI 1.3, HDCP 1.4 Supports 1080p@60Hz Extend over a Cat5e/6 cable up to 120m Support IR frequence 20-60kHz Layout Transmitter Package contents • • • • • HDMI HDbitT Extender TX & RX Power adapter DC 5V/1A x2 IR Blaster cable IR Receiver cable Quick Start Guide 1.
PAGE 2
Receiver Application 1. Point to point: Up to 120m over Cat6 cable 1. 2. 3. 4. 5. 6. 7. 8. Reset: Press to reset if HDMI extender doesn’t work properly HDMI Out: Connect with HDMI display IR IN: Connect with IR Receiver cable Power Jack: Connect with power adapter Power LED: On when the device is powered RJ45: Link to the TX via a Cat5e/6 cable Activity LED: Bilnks during data transmission LINK LED: On when the TX/RX connected HDMI HDbitT Over Cat6 Extender with IR - 120m Quick Start Guide 2.