sic 2-Port DVI Dual-Link Smart Console Switch with USB 3.
Goo A\ Safety and Notice The device has been tested for conformance to safety regulations and requirements, and has been certified for international use. However, like all electronic equipment, the device should be used with care, Please read and follow the safety instructions to protect yourself from possible injury and to minimize the risk of damage to the unit. Follow all instructions and warnings marked on this unit. Do not attempt to service this unit yourself, except where explained in this manual.
-Features « DVI 1.0 Dual Link compliant, Video bandwidth bps + Supports dual-link DVI resolution up to 4K@30Hz or 2K@60Hz + Support separate line input and output « Plug and Play without any driver needed + Supports built-in 4-port USB 3.
Rear Panel Console USB Ports: Connect to keyboard & mouse KVM Video IN 1-2: Connect the DVI cable to PC Console Video OUT: Connect the DVI cable to a display +12V DC: +12V DC power jack Power Status: Power indicator LED Micro USB: For F/W update USB 3.0 Hub: Connect to USB devices Stereo Audio OUT: Connect to analog stereo audio speaker Stereo Audio IN: Connect to analog stereo audio source . KVM USB B): Connect the USB cable to PC . KVM Stereo Audio OUT 1-2: Connect the stereo cable to PC .
Boe Dip Switch ON[$] KVM firmware update mode PIN#1 Offish | Working mode PIN#2 firmware update mode OFF[#] | Working mode.
oc Hotkey Default setting, all of the following commands begin by pressing the [Scroll Lock] key twice.
oc Firmware update Firmware update is proceeded through Micro-USB KVM F/W update 1. 2, Connect the Micro-USB to USB cable between PC and device Set dip switch PIN#1 to ON[$] and then power on device Open firmware update software and then select COM Port Click “KVM” button to open "KVM Firmware Update” windows Check all items and click each button to select the file which you want to write into device.
oc MCU F/W update 1. 2. Connect the Micro-USB to USB cable between PC and device Set dip switch PIN#2 to ON[#] and then power on device Open firmware update software and then select COM Port Click “MCU” button to open “MCU Firmware Update” windows Click “Load File” button to select the file which you want to write into device.