Signify Classified - Internal SMART RF MODULE GEN II SMART RF MODULE GEN II USER MANUAL Changing Content List: Updated Date 2019/10/12 Change Request No.
Signify Classified - Internal SMART RF MODULE GEN II 1) Module layout and drawing a. Module picture b. Dimensions Name Value Tolerance Width (mm) 20.8 ±0.2 Length (mm) 35.0 ±0.
Signify Classified - Internal SMART RF MODULE GEN II
Signify Classified - Internal SMART RF MODULE GEN II 2) Electrical Specification Name Value Tolerance Vcc voltage (V) 5V ±5% Current (normal, mA) 40 Storage temperature (°C) -40~120 Remarks 3) RF Specification Spec Item Conditions Min Frequency tolerances (ppm) Continuous single tone Frequency range (MHZ) Output power (dBm) Typical +/-40 2400~2483.5 Measured at antenna feed point 4.0±1.0 30 – 1000MHz -36 1 – 12.75GHz -30 1.8 – 1.9GHz -47 5.15 – 5.
Signify Classified - Internal SMART RF MODULE GEN II PER < 1%,tested on the feeding Receiver Sensitivity (dBm) -99 point of antenna when connected to motherboard TRP -2dBm (i.e.
Signify Classified - Internal SMART RF MODULE GEN II Name No.
Signify Classified - Internal SMART RF MODULE GEN II 6) Integration instructions 6.1 list of applicable FCC rules This device complies with part 15.247 of the FCC Rules. 6.2 Summarize the specific operational use conditions This module can be used in household electrical appliances as well as lighting equipment’s. The input voltage to the module should be nominally 4.75~5.25V ,typical value 5.0VDC and the ambient temperature of the module should not exceed 85℃.On-board PCB antenna gain is 4dBi.
Signify Classified - Internal SMART RF MODULE GEN II antenna arrangement is not covered by this certification. The antenna is not field replaceable. If the antenna needs to be changed, the certification should be re-applied. 6.3 Limited module procedures Not applicable 6.4 Trace antenna designs Not applicable 6.5 RF exposure considerations This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
Signify Classified - Internal SMART RF MODULE GEN II 6.8 information on test modes and additional testing requirements a) The modular transmitter has been fully tested by the module grantee on the required number of channels, modulation types, and modes, it should not be necessary for the host installer to re-test all the available transmitter modes or settings.
Signify Classified - Internal SMART RF MODULE GEN II • o [TH,RfTest,init,0] //RF test initialize o [TH,RfTest,setmode,unmodtx] // setting CW mode o [TH,RfTest,setmode,txstream] //setting modulated wave mode o [TH,RfTest,setchnl,18] //set channel 18 o [TH,RfTest,setpwr,4] //set RF power 4dBm o [TH,RfTest,start,0] //start to transmit For BLE TX, similar function can be activated by using HueApprobationTool.exe attached BLE test FW.rar Zigbee Test FW.rar HueApprobationTool. rar 6.
Signify Classified - Internal SMART RF MODULE GEN II unintentional radiator, the transmitter shall be placed in the receive mode or idle mode, if possible. If receive mode only is not possible then, the radio shall be passive (preferred) and/or active scanning. In these cases, this would need to enable activity on the communication BUS (i.e., PCIe, SDIO, USB) to ensure the unintentional radiator circuitry is enabled.
